Installation Guide

Message Cause Action
Low battery / Empty
battery
The robotic lawnmower cannot find the charg-
ing station.
Check that the charging station and the guide
wire are installed in accordance with the in-
structions in Installation of the guide wire on
page 18 .
The guide wire is broken or not connected. Check that the indicator lamp in the charging
station flashes yellow. See the solution in, Indi-
cator lamp in the charging station on page 40 .
The battery is spent. Replace the battery. See Replacing the battery
on page 36 .
The charging station’s antenna is defective. Check if the indicator lamp in the charging sta-
tion flashes red. See Indicator lamp in the
charging station on page 40 .
Wrong PIN Wrong PIN code has been entered. Five at-
tempts are permitted, and the keypad is then
blocked for five minutes.
Enter the correct PIN code. Contact your local
McCULLOCH representative if you forget the
PIN code.
Wheel motor overloa-
ded,right
The robotic lawnmower has got caught in
something.
Free the robotic lawnmower and rectify the rea-
son for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before using
the robotic lawnmower. Wheel motor overloa-
ded, left
No drive The robotic lawnmower has got caught in
something.
Free the robotic lawnmower and rectify the rea-
son for the lack of drive. If it is due to wet
grass, wait until the lawn has dried before using
the robotic lawnmower.
The working area includes a steep slope. Maximum guaranteed slope is 25%. Steeper
slopes should be isolated. See Slopes on page
16 .
The guide wire is not laid at an angle on a
slope.
If the guide wire is laid on a slope, it must be
laid at an angle across the slope. See Installa-
tion of the guide wire on page 18
Charging station
blocked
The contact between the charging strips and
contact strips may be poor and the robotic
lawnmower has made a number of attempts to
charge.
Put the robotic lawnmower in the charging sta-
tion and check that the charging strips and con-
tact strips make good contact.
An object is obstructing the robotic lawnmower. Remove the object.
The charging station is tilted or bent. Confirm that the charging station is placed on a
fully flat and horizontal ground. The charging
station must not be tilted or bent.
Stuck in charging sta-
tion
There is an object in the way of the robotic
lawnmower preventing it from leaving the
charging station.
Remove the object.
Upside down The robotic lawnmower is leaning too much or
has turned over.
Turn the robotic lawnmower the right way up.
Needs manual charg-
ing
The robotic lawnmower is set in the MAN oper-
ating mode.
Place the robotic lawnmower in the charging
station. This behaviour is normal and no action
is required.
175 - 001 - 17.03.2017 39