Corporation Brush Cutter Instruction Manual

7
3. Position the lower shoulder strap clamp
under the shaft and align the upper and
lower clamp screw holes.
Upper shoulder
strap clamp
Screws
Lower shoulder
strap clamp
4. Insert two screws into the screw holes.
5. Secure shoulder strap clamp by tighten-
ing screws with a hex wrench.
76 cm
HARNESS
ADJUSTMENT
FOR BALANCE
10 -- 30 cm
above
ground
15 cm
below
waist
76 cm
ATTACHING T HE SHIELD
WARNING: The shield must be prop-
erly installed. The shield provides partial
protection to the operator and others from the
risk of thrown objects, and is equipped with a
line limiter blade which cuts excess line to the
proper length. The line limiter blade (on un-
derside of shield) is sharp and can cut you.
1. Insert bracket into slot on shield.
2. Pivot shield to align holes in shield and
bracket.
Slot
Shield
Bracket
3. Secure shield to bracket with bolt.
Bolt
CONFIGURING YOUR UNIT
You can configure your unit using a cutting head
for grass and light weeds, or a weed blade for
cutting grass, weeds, and brush up to 1 cm in
diameter. To assemble your unit, go to the sec-
tion for the desired configuration and follow the
in st ru ct i o n s.
ASSEMBLY INFORMATION --
TRIMMER HEA D
TRIMMER
HEAD
NOTE: Remove the blade before attaching the
trimmer head. To remove blade, align hole in the
dust cup with the hole in the side of the gearbox
by rotating the blade. Insert a small screwdriver
into aligned holes. This will keep the shaft from
turning while loosening the blade nut. Remove
blade nut by turning clockwise. Remove the
screwdriver. Remove both washers and blade.
See INST AL LATION OF THE METAL BLADE
for illustrations. Be sure to store all parts a nd in-
structions for future use. Never use the trimmer
head with the metal blade installed.