IO T A RM N NFO I T TA N se R O ence r P u e f e M e r I efo re r b u t d u a f Re n for i a t e &r For all customer enquiries or for replacement parts, contact:- ☎ 01325 300303 www.eletrolux.com/mcculloch eop.customer.services@electrolux.co.
1 Carton Contents trigger adjustable handle 2 handle knobs adjustable shoulder harness mode indicator 2 handle bolts Air inlets debris bag frame cutting lines debris bag instruction manual nozzle IMPORTANT ! Please check the contents of the carton are correct BEFORE assembling your new Flymo product.
2 3. Do not use the product if the electric cables are damaged or worn. 4. Immediately disconnect from the mains electricity supply if the cable is cut, or the insulation is damaged. Do not touch the electric cable until the electrical supply has been disconnected. Do not repair a cut or damaged cable. Replace it with a new one. 5. Your electric cable must be uncoiled, coiled cables can overheat and reduce the efficiency of the product. 6. Do not pull cable around sharp objects. 7.
3 Assembly Instructions A C B D To Attach Debris Bag to Bag Frame With bag frame on the ground:1. Fit first two holes on the plastic trim of the debris bag to the first two location points on the front of the bag frame (where debris fin is attached). (A) 2. Fit next hole on the plastic trim to next location point on bag frame. (B) 3. ...until all holes on the plastic trim of the debris bag are securely located to bag frame. (C) • ENSURE THE DEBRIS BAG IS FITTED SECURELY TO THE BAG FRAME.
4 Assembly instructions F To 1. 2. 3. Remove Debris Bag From Product (F) Gently press bag latch (F1) down. See fig F. Lower handle of bag frame away from product. Move bag frame forward. 1 G Fitting the Handle Bolt (G) 1. Place handle bolt into the location slot on the product and slide into place.(G). 2. Repeat on the other side. Fitting the Handle (H) 1. Locate handle onto handle bolts on each side of the product. 2. Secure handle by turning handle knobs clockwise. (H) 3.
5 How to Use WARNING The use of eye protection is recommended. The use of ear protection is recommended. To prevent dust irritation, the wearing of a face-mask is recommended. Never point your product at bystanders. Do not use your product in the rain. Do not leave your product outdoors while it is raining. IMPORTANT!: YOUR PRODUCT WILL NOT OPERATE UNTIL THE FULLY ASSEMBLED DEBRIS BAG AND FRAME ARE PROPERLY FITTED. BEFORE USE: ENSURE THERE ARE NO GAPS BETWEEN THE DEBRIS BAG AND THE PRODUCT.
6 Caring for your Gardenvac WARNING Never use water for cleaning your product, use only a dry cloth. Do not clean with chemicals or solvents, some can destroy critical plastic parts. After Using Your Gardenvac (Q1, 2, 3 & 4) 1. Switch off and disconnect from the mains electricity supply before cleaning your product. 2. Always empty the debris bag. 3. Take extra care to clean around the cutting head and the collection chute.
Guarantee & Guarantee Policy If any part is found to be defective due to faulty manufacture within the guarantee period, Electrolux Outdoor Products, through its Authorised Service Repairers will effect the repair or replacement to the customer free of charge providing: (a) The fault is reported directly to the Authorised Repairer. (b) Proof of purchase is provided. (c) The fault is not caused by misuse, neglect or faulty adjustment by the user. (d) The failure has not occurred through fair wear and tear.