Operation Manual

ASSEMBLING AND ADJUSTMENTS
70 – English
General
Handle
Assembly
Top handle
Place the handlebar’s tubular construction in direct
opposite to the lower part of the handlebar. Tighten the
knobs properly.
All but M40-125
M40-125
Use enclosed straps to secure cables to the handle. Do
not overstretch cables when mounting.
Settings
Handle height (all but M40-125)
• Loosen the lower knobs.
• Adjust the height. Tighten the knobs properly.
Cutting height
Move the lever to the back for higher cutting height and to
the front for lower cutting height.
M40-125, M46-125 has four controls, one for each wheel.
!
IMPORTANT! Prevent unintentional
starting by removing the ignition cable
from the spark plug.
NOTICE! Do not set the cutting height too low as there
is a risk that the cutters might hit ground with
unevenness.