Operation Manual

a) Push the arrow buttons
to select
Current day to only set the current day
to factory settings.
b) Push the arrow buttons to select All
week to reset all schedule settings to
factory settings.
3. Push the OK button.
3.10.2.6 Day mode
The Day mode means that the product starts
mowing at 08:00 / 8 am and mows the specified
operation hours.
3.10.2.7 Night mode
The Night mode means that the product starts
mowing at 20:00 / 8 pm and mows the specified
operation hours.
3.10.3 Security level
There are 3 security levels for the product.
Function Low Medium High
Alarm X
PIN-code X X
Time lock X X X
• Alarm - An alarm goes off if the PIN-code is
not entered within 10 seconds after the
STOP
button is pushed. The alarm also
goes off when the product is lifted. The
alarm stops when the PIN-code is entered.
• PIN-code - The correct PIN-code must be
entered to get access to the Menu structure
of the product. If the incorrect PIN-code is
entered 5 times, the product is locked for a
time. The lock is extended for each new
incorrect try.
• Time lock - The product locks if the PIN-
code has not been entered in 30 days. Enter
the PIN-code to get access to the product.
3.10.3.1 To set the security level
Select 1 of 3 security levels for your product.
1. Do steps 1–3 in
To get access to the menu
on page 20
.
2. Use the arrow buttons
and the OK button
to move through the menu structure Settings
> Security > Security level .
3. Use the arrow buttons and the OK button
to select the level of security.
4. Push the OK button.
3.10.3.2 To change the PIN-code
1. Do steps 1–3 in
To get access to the menu
on page 20 .
2. Use the arrow buttons and the OK button
to move through the menu structure Settings
> Security > Advanced > Change PIN-code .
3. Enter the new PIN code.
4. Push the OK button.
5. Enter the new PIN code.
6. Push the OK button.
7. Make a note of the new PIN code. Refer to
Introduction on page 3 .
3.10.4 Lawn shield
The Lawn shield automatically adjust the cutting
time to the growth of the grass. The product is
not permitted to operate more than the schedule
settings.
The first operation of the day is set by the
schedule settings. Then the Lawn shield selects if
the product will continue to operate.
Note: The Lawn shield is reset if the product
stops to operate for more than 50 hours or if a
Reset of all user setting is done. The Lawn shield
is not changed if a Reset of schedule settings is
done.
3.10.4.1 To set the Lawn shield
1.
Do steps 1–3 in To get access to the menu
on page 20
.
2. Use the arrow buttons and the OK button
to move through the menu structure Settings
> Lawn shield > Use Lawn shield .
3. Push the OK button to select the Lawn
shield.
4. Push the BACK button.
22 - Installation 985 - 004 - 22.01.2019