Operation Manual
3.10.4.2 To set the Lawn shield frequency
Set how frequently the product must cut the
grass when the Lawn shield is in use. There are
3 frequency levels: Low, Mid and High. The
higher the frequency, the longer the product is
allowed to work.
1. Do steps 1–3 in
To get access to the menu
on page 20
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> Lawn shield > Cutting time
.
3. Use the arrow buttons to select
Low, Mid
or
High
frequency.
4. Push the BACK button.
3.10.5 Lawn Coverage
The Lawn Coverage function is used to guide the
product to remote parts of the work area.
3.10.5.1 To set the Lawn Coverage function
1. Do steps 1–3 in
To get access to the menu
on page 20
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> Installation > Lawn Coverage > Area 1
.
3. Use the arrow buttons to select the % of
the cutting time the product must cut the
area. The % is equal to the % of the area in
relation to the complete work area.
a) Measure the area.
b) Divide the area with the work area.
c) Convert the result to %.
30%
20%
4. Push the BACK button.
3.10.5.2 To do a test of the Lawn Coverage
function
1. Put the product in the charging station.
2. Do step 1-3 in
To get access to the menu on
page 20
.
3. Use the arrow buttons and the OK button to
move through the menu structure
Settings
>
Installation > Lawn Coverage > Area 1 >
More > Test
.
4. Push the OK button.
5. Push the START button.
6. Close the hatch.
7. Make sure the product can find the area.
3.10.5.3 To disable or enable the Lawn
Coverage function
Disable or enable the
Lawn Coverage
function for
each area.
1. Do steps 1–3 in
To get access to the menu
on page 20
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> Installation > Lawn Coverage > Area 1 >
Disable
.
3. Push the OK button.
4. Push the BACK button.
3.10.5.4 To reset the Lawn Coverage settings
You can reset the
Lawn Coverage
settings for
each area and use the factory setting.
1. Do steps 1–3 in
To get access to the menu
on page 20
.
2. Use the arrow buttons and the OK button
to move through the menu structure
Settings
> Installation > Lawn Coverage > Area 1 >
More > Reset
.
3. Push the OK button.
3.10.6 To set the starting point
This function allows you to control how far the
product drives along the guide wire from the
charging station before it starts operating. The
factory setting is 60 cm and the maximum
distance is 300 cm.
985 - 004 - 22.01.2019 Installation - 23