OPENconnectors Command Line Interace User Manual
2
CLI Commands
McDATA OPENconnectors Command Line Interface USER MANUAL P/N 620-000134-300
2-6
FRQILJLSHWKHUQHW
6\QWD[ ethernet ipAddress gatewayAddress subnetMask
3XUSRVH This command sets the Ethernet network settings.
'HVFULSWLRQ The Telnet connection can be lost when these Ethernet network settings are
changed.
If the IP address is reconfigured, your Telnet client must be reconnected to
the new IP address. A new login will be requested.
3DUDPHWHUV This command has three parameters.
&RPPDQG([DPSOH Root> config ip ethernet 10.0.0.0 0.0.0.0 255.0.0.0
FRQILJLSVKRZ
6\QWD[ show
3XUSRVH This command shows the LAN configuration.
3DUDPHWHUV This command has no parameters.
&RPPDQG([DPSOH Root> config ip show
ipAddress Specifies the new IP address for the director or
switch. The address must be entered in dotted
decimal format (for example, 10.0.0.0).
gatewayAddress Specifies the new gateway address for the
Ethernet interface. The address must be entered
in dotted decimal format (for example, 0.0.0.0).
subnetMask Specifies the new subnet mask for the Ethernet
interface. The address must be entered in dotted
decimal format (for example, 255.0.0.0).