User Guide

c. Using an adjustable wrench, install a a"
(9.5mm) NPT compression fitting base (K)
to the upper tapping (L) in the control (A).
Tighten to 31 ft•lb (42 N•m).
A
L
K
N
M
d. Using a pipe wrench, install a 2" (13mm)
nipple (M) into the upper tapping (N).
Tighten to 31 ft•lb (42 N•m).
e. Using a pipe wrench, install the pipe tee (P)
(provided) onto the nipple (M) in the upper
tapping (N). Tighten to 31 ft•lb (42 N•m).
N
M
P
f. Using an adjustable wrench, install
1
/2 (13mm) NPT
compression fitting base (U) into the upper tee (P).
Tighten to 31 ft•lb (42 N•m). Place the compression nut
(R) and compression ring (S) over the top of tubing (Q).
Insert tubing (Q) into compression base (U). Turn
compression nut (R) hand tight. DO NOT TIGHTEN.
IMPORTANT: Do not use tape or pipe
sealant on the compression fittings.
Q
U S R
P
4