Install Instructions

4
d. Using the flatblade screwdriver, loosen
the two (2) screws that secure the
cover (G) to the control about 1-1/2
turns and remove cover.
b. Apply a small amount of pipe dope to the first
external threads (D) of the probe (A).
c. Using a wrench, tighten the probe (A) into the
tapped connection (E) that was determined in
Step 1 of these instructions. Tighten to 47 ft•lb
(64 N•m).
NOTE: Be sure to align the probe so that the
mounting screws (F) are in a hori zontal position.
I M P O RTA N T: Do not use Teflon
®
tape or thread
sealant.