Owner`s manual

12
C100C Front Panel Controls, Displays,
Push-Buttons, and Switches
BALANCE control
allows you to adjust
the relative volume
levels of each channel
signal in 1dB steps.
POWER
switch turns
all AC power
completely
ON or OFF.
RECORD switch selects
the program signals that
are fed to the balanced
and unbalanced TAPE
outputs.
LIS PROCESSOR
push-button turns
the Listen Processor
loop on or off.
LISTEN switch selects
the program signals
that are fed to the bal-
anced and unbalanced
outputs.
VOLUME control
adjusts the volume
level at the balanced
and unbalanced out-
puts as well as adjust-
ing input level cali-
bration.
DISPLAY indicates the volume level in dB
with 0.5dB or 1.0dB steps, or percentage of
maximum volume from 1 to 100. The dis-
play also indicates input level calibration as
well as Balance adjustments.
REC PROCESSOR
push-button turns the
Record Processor
loop on or off.
REC MONITOR
push-button switches
the RECORD Output
signals to the Listen
circuit so you can
hear the program
signals sent to the
Record outputs.
MONO push-
button com-
bines left and
right stereo
signals to
mono at all
Main, Ampli-
fier and Lis-
ten Outputs.
INPUT TRIM allows
input levels of any pro-
gram source to be
matched to the level of
the Tuner input.
DISPLAY push-button
switches the display to
indicate either volume
level in dB, or percent
of maximum volume.
MUTE push-button
mutes audio in all
Listen outputs.
SPKR/AMP 1 and 2
push-buttons allow
the C100 to switch
AC power control
and audio to two
separate stereo
power amplifiers.
STANDBY/ON push-
button turns the C100
ON, or OFF (Standby).
It is also used to reset
all the C100 micropro-
cessors.
C100C Front Panel Controls, Displays, Push-
Buttons, and Switches