Owner`s manual

Installation

The C100 can be placed upright on a table or shelf, stand-

ing on its four feet. It also can be custom installed in a piece

of furniture or cabinet of your choice. The required panel

cutout, ventilation cutout and unit dimensions are shown.

Always provide adequate ventilation for your C100.

Cool operation ensures the longest possible operating life

for any electronic instrument. Do not install the C100 di-

rectly above a heat generating component such as a high

powered amplifier. If all the components are installed in a

single cabinet, a quiet running ventilation fan can be a defi-

nite asset in maintaining all the system components at the

coolest possible operating temperature.

A custom cabinet installation should provide the follow-

ing minimum spacing dimensions for cool operation. Allow

at least 1-1/2 inches (3.8cm) above the unit so airflow is not

obstructed. Allow 17-1/2 inches (44.5cm) depth behind the

mounting panel, which includes clearance for connectors.

Allow 1-1/8 inches (2.9cm) in front of the mounting panel

for knob clearance. Be sure to cut out a ventilation hole in

the mounting shelf according to the dimensions in the draw-

ing.

Front View of both the

C100C and C100P custom

installed

Side View of both the

C100C and C100P

custom installed

Bottom View of both the

C100C and C100P custom

installed

Installation