Owner`s manual

7
How to Connect the C100C
How to Connect the C100C
1. Connect a DB25 (25 conductor, shielded straight
through male-to-female) cable from the C100C socket
to the matching socket on the C100P.
2. Connect the C100C power cord to an AC outlet.
3. Connect a Power Control cable from the top MAIN
AMPLIFIER POWER CONTROL jack to one McIn-
tosh Power Amplifier and the bottom jack to a second
McIntosh Power Amplifier. If you are connecting to a
McIntosh Stereo Power Amplifier use the top jack.
NOTE: Turn on signals will come first from the top jack, and
then the bottom jack approximately ½ second later.
4. Connect the AC power cords of source components to
the SWITCHED AC outlets, if you want them to come
on and off with the C100.
5. Connect components that require AC power at all times,
to the UNSWITCHED AC outlet.
6. Connect the McIntosh Remote Controllable Components
Data Ports to the approiate C100 Data Port Jack using
a Data Cable.
7. Connect the McIntosh RCT Translator to the SUM
DATA PORT using a Data Cable.
8. Connect an RG6 or RG59U coaxial cable from the EXT
(external) Sensor jack to a McIntosh Keypad or IR sen-
sor.
NOTE: A Data cable consists of a mono or stereo shielded
cable with 1/8 inch mini phone plugs on each end.
Connections are to the tip (+) and sleeve (-) of the
plugs. (McIntosh Part No. 170-202)
Power Amplifier
Top View
insert
To AC Outlet
To AC Outlet
McIntosh
Sensor or
Keypad
McIntosh Power Amplifier
(Right Channel)
McIntosh Power Amplifier
(Left Channel)
McIntosh Tuner
McIntosh CD Player
McIntosh C100P