Owner`s manual

8
C100P Rear Panel Switches and
Connections
TO C100C Connector
accepts a DB25, 25
conductor cable that
connects all control
signals and power sup-
ply voltages from the
C100C to the C100P.
MAIN Balanced
OUTPUTS contain
Listen program
signals at all times.
AMPLIFIER 1 and 2
Balanced OUTPUTS
contain Listen signals
and turn on/off with the
front panel SPKR/AMP
push-buttons.
TAPE 1 Balanced
OUTPUTS contain
record out signals
LISTEN MAIN un-bal-
anced OUTPUTS con-
tain Listen program sig-
nals at all times.
LISTEN un-balanced OUT-
PUTS 1 and 2 contain Listen
signals and turn on/off with the
front panel SPKR/AMP push-
buttons.
LISTEN PROCESSOR
FROM and TO allows an
external signal processor to
be connected for use in the
Listen mode.
RECORD PROCESSOR
FROM and TO allows an
external signal processor to
be connected for use in the
Record mode.
LINE 1, LINE 2 and TAPE 1
Balanced INPUTS accept high
level program source signals.
TAPE 2, Tuner, and CD un-
balanced INPUTS accept
high level program source
signals.
TAPE 1, TAPE 2
un-balanced OUT-
PUTS contain
record out signals
AUX 1 accepts high level program
source signals. PH 1 (MC) accepts low
level signals from a Moving Coil phono
cartridge and PH 1 (MM) accepts sig-
nals from a Moving Magnet phono car-
tridge. The small slide switch selects
which one of these three inputs is active
when either front panel LISTEN or
RECORD switch is set to PHX/AUX 1.
AUX 2 accepts high level program
source signals. PH 2 (MM) accepts
signals from a Moving Magnet phono
cartridge. The small slide switch se-
lects which one of these inputs is ac-
tive when the front panel LISTEN or
RECORD Selector switch is set to PH/
AUX2.