Owner`s manual

22
and/or C1000T are connected to the correct
sockets on the Rear Panel of the C1000C. Refer
to page 12 for the C1000P, refer to page 14 for
the C1000T or refer to page 16 for the C1000P
and C1000T combination. After correcting the
cable connection error, reconnect the AC Power
Cord to the Rear Panel of the C1000C. Perform
Step one again.
2. When both Preamplifiers (C1000P and C1000T)
are connected to the same C1000 Controller, the
C1000P Preamplifier default Input Title names
will have a number 1 added to the end of the
Title. Refer to figure 3b. The C1000T
Preamplifer default Input Title names will have
a number 2 added to the end of the Title. Refer
to figure 3c.
3. There is no Input Title “D/A2” available when
both Preamplifiers (C1000P and C1000T) are
connected to the same C1000 Controller, the
McIntosh MDA1000 may be connected to either
preamplifier.
2. Press the C1000C Front Panel SETUP push-button
once. The LED above the SETUP Push-button will illu-
minate and the Front Panel Display will indicate CON-
TROLLER. The “Controller” is the first of the two
main menus. The second main menu is named
“Preamp” and will be accessed in step 5. Refer to fig-
ures 2 and 5.
How to Operate the Setup Modes
Your McIntosh C1000 has been factory configured for de-
fault operating settings that will allow immediately enjoy-
ment of superb audio without the need for further adjust-
ments. If you wish to make changes to the factory default
settings, a Setup Feature is provided to customize the oper-
ating settings using the Front Panel Alphanumeric Display
on the C1000C Controller. The setup fuctions available for
change and/or adjustments are dependent upon connection
of the Preamplifier(s) connected to the C1000C Controller,
C1000P, C1000T or both.
1. The Red LED above the STANDBY/ON push-button
lights to indicate the C1000 is in Standby mode and is
connected to a live AC Outlet. To switch On the C1000,
press the STANDBY/ON push-button. Refer to figure
2. The Alphanumeric Display will indicate the last input
listened to. If this is the first time the C1000 is switched
on, the display will indicate “15 TUNER”, refer to fig-
ure 3a. If both Preamplifiers (C1000P and C1000T) are
connected to the same C1000 Controller the display will
indicate “15 TUNER1”, refer to figure 3b.
Notes: 1. Dependent upon which Preamplifier (C1000P
and/or C1000T) is connected to the C1000C, the
Front Panel Alphanumeric Display will indicate
different operational messages when switched
On, refer to page 42 for additional information.
If the Front Panel Alphanumeric Display
indicates CABLE ERROR, refer to figure 4,
remove the AC Power Cord from the Rear Panel
of the C1000C. Then check to verify that both
interconnect cables coming from the C1000P
Figure 3a
Figure 5
Figure 4
Figure 2
Figure 3b
Figure 3c