Owner`s manual

Accessory Control

When the Trigger A or B Power Control Outputs on the

C1000 Controller are used, one of the Triggers may be as-

signed to switched On or Off by using the ACCessory Push-

button on the supplied HR54 Remote Control. To select ei-

ther Trigger A or B for remote operation, perform the fol-

lowing steps:

1. Press the SETUP Push-button twice to access the Setup

Preamp Mode unless the C1000C is already in the

Setup Preamp Mode.

2. Rotate the BALANCE (Menu) Control until the Alpha-

numeric Display indicates “ACC CONTROL --”.

Refer to figure 38.

3. Rotate the LISTEN (Select) Control until the desired

Trigger A or B appears in the Display, e.g. “ACC

CONTROL A”. Refer to figure 39.

Note: Devices connected to the Trigger (A or B) Jacks

will be effected when Trigger (A or B) in SETUP is

changed.

4. If no other adjustments are to be made at this time,

press the SETUP Push-button to exit the Setup Preamp

Mode or proceed to the next desired Setup Preamp

Mode for adjustment.

Figure 38

Figure 39

Setup, con’t