Owner`s manual

35
How to Operate the Remote Control
continuously from station to station. Press +10 to start the
automatic brief audition of each of the presets stored in the
tuner memory. Press +10 a second time to stop on a station
preset and exit the Review process.
Volume
Press the UpS or DownT VOLUME Push-button to raise
or lower the listening volume level.
Note: The Record Signals present at CDR and SRVR
OUTPUTS are not affected by volume changes.
Amplifier Selection
Press the 2nd push-button followed by the OUTPUT 1 or 2
push-buttons to control the rear panel OUTPUTS 1, 2
which can feed signals to a power amplifier or other acces-
sory component.
Acc On
Press ACC ON to turn the power ON to a McIntosh Disc
Player.
Acc Off
Press ACC OFF to turn the power
OFF to a McIntosh Disc Player.
Pause
Press Pushbutton to perform various
functions on a variety of McIntosh
Components. It will also pause the
playing of a disc or tape player. The
Push-button will also allow for quick
exiting from the active menu when in
the setup mode. The Push-button is
also used as an Enter Push-button with
some McIntosh components.
Secondary Remote
The C1000 comes with two Remote
Controls. The HR061 (full functions)
illustrated on the opposite page and the
HR1000 (basic functions) in figure 60.
The push-button titles on the HR1000
are the same as on the HR061 Remote
Control and function in the same man-
ner in controlling the C1000.
How to Operate by Remote Control
The supplied Remote Control is capable of directly control-
ling the functions of contemporary McIntosh Source Com-
ponents connected to the C1000.
Mute
Press the MUTE Push-button to mute audio. The Record
Signals present at the CDR and SRVR OUTPUTS are not
affected by the MUTE function. The C1000 Front Panel
Alphanumeric Display will indicate the word MUTE. Press
MUTE a second time to unmute audio.
Mono
Press the MONO Push-button to switch from Stereo to
Mono for the selected Listen Signal.
Trim
Press the TRIM Push-button, followed by the LEVEL UpS
or DownT Push-button to select various sound adjustments
and functions.
Note: Refer to “How to Operate the C1000” starting on page
38 for additional information.
Input Source Selection
Press one of the appropriate Source Push-button or the In-
put W or X Push-buttons to select the desired program
source.
Note: When directly selecting sources with Title names
ending with a “2” or “3”, the appropriate Numbered
Push-button needs to be press after the push-button
with the Titled Name is pressed. e.g. for Input DVD2,
press the DVD Push-button followed by the “2” Push-
button.
Disc, Server and Tape Functions
Use these push-buttons to operate a DVD Player, CD
Player, CD Changer, Music Server or Tape Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre-
sets, tracks on discs or selections on a Music Server.
Disc and Track
Use the DISC and TRACK Push-buttons when a Disc
Player or Music Server is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel UpS or
DownTPush-button to move from station to station. Press
and hold a Channel UpS or DownT Push-button to move
Figure 60