Owner`s manual

40
How to Operate the C1000, con’t
Figure 87
Figure 85
Figure 86
Figure 89
Figure 91
Figure 88
Figure 90
How to use the Passthru Mode
When the C1000 is connected together with a McIntosh
Multichannel A/V Control Center or Surround Decoder and
has the PASSTHRU MODE activated it will automatically
turn-on when the A/V Control Center or Surround Decoder
is turned On. It will indicate on the Front Panel Alphanu-
meric Display “PASSTHRU”. Refer to figure 84.
The C1000C Front Panel Controls, Push-buttons and the
Remote Control Push-buttons are deactivated as long as the
Passthru Mode is active. The settings for the LISTEN and
RECORD Processor and OUTPUTS 1&2 remain un-
changed when the C1000 is in the Passthru Mode.
Reset of Microprocessors
In the event that the controls of the C1000 stop functioning
press and hold in the STANDBY/ON Push-button. Three to
four seconds latter the Front Panel Alphanumeric Display
will indicate “DETECT SYSTEM”, at this point release
the STANDBY/ON Push-button. This will reset the C1000
microprocessors. Refer to figure 85.
Note: The above condition is usually caused by either
interruptions in AC power and/or major changes in
voltage.
Configuration Change
When a change is made to a C1000 System (Controller and
one or both Preamplifiers) by adding or removing a Pream-
plifier, the Front Panel Alphanumeric Display will indicate
“CONFIG CHANGE” and the
LED indicators above the
SETUP and REC MONITOR
Push-buttons will be flashing.
Refer to figures 86 and 87. If
there is not to be any changes
to the C1000 System, but
rather reconnecting a Preampli-
fier that was prevoiusly connected to the C1000 Controller
perform the following:
1. Remove the AC Power Cord from the Rear Panel of
C1000 Controller.
Figure 84
2. Reconnect the previously connected Preamplifier.
3. Re-attach the AC Power Cord.
4. The C1000 System will automatically reset itself and
will retain any changes that where previously made in
the SETUP Mode.
If the change to the C1000 System is a result of changing
Preamplifier Types (C1000P or C1000T) or the addition of
a second Preamplifier (C1000P or C1000T) then perform
the following steps:
1. Remove the AC Power Cord from the Rear Panel of
C1000 Controller.
2. Connected the Preamplifier(s) to the C1000 Controller.
3. Re-attach the AC Power Cord.
4. Press and hold in the SETUP and REC MONITOR
Front Panel Push-buttons until the Alphanumeric Dis-
play indicates “DETECT SYTEM”, then release the
two Push-buttons.At this point several messages will
appear on the Alphanumeric Display depending on the
C1000 System make up. Refer to figures 88 thru 91.
5. For any changes from the default settings that are de-
sired go to page 24 SETUP to perform them at this
time.