Owner`s manual

10
How to Operate the C15
How to Operate the C15
Power On
Press the POWER switch to ON. The Red LED above the
STANDBY/ON push-button, lights to indicate the C15 is
in Standby mode. To turn On the C15, press the
STANDBY/
ON push-
button. The
MUTE LED
will light for
approxi-
mately two
seconds af-
ter turn on.
Refer to fig-
ure 1.
Note: For normal operation, turn the C15 On and Off with the
Standby/On push-button. If the amplifier is not going to
be used for an extended time, turn off all AC power with
Power Switch. You may also turn On the C15 by simply
pressing the desired source selection push-button switch
on the Front Panel or Remote Control.
Source Selection
Select the desired listening source with the appropriate
Front Panel
or Remote
Control
Push-but-
ton. Refer
to figure 2
and page
13 for addi-
tional infor-
mation.
Volume Control
Adjust the VOLUME control for the desired listening
level.
Balance Control
Adjust the BALANCE control as needed to achieve ap-
proximately equal listening volume levels in each loud-
speaker. Turn the BALANCE to the Left to emphasize the
left channel by reducing the level of the right channel. Turn
the BALANCE to the right to emphasize the right channel
by reducing the level of the left channel.
Bass and Treble Controls
Adjust the BASS and TREBLE controls to suit your listen-
ing preferences. The bass or treble intensity can be in-
creased with clockwise rotation and decreased with coun-
terclockwise rotation. All tone control circuit elements are
removed from the signal path when the controls are in the
center or flat position.
Mono
Press the MONO push-button to combine left and right ste-
reo signals to mono at the OUTPUTS 1 and 2 and HEAD-
PHONES output.
Mute
Press the MUTE push-button to mute audio in all outputs
except the HEADPHONES. The MUTE LED above the
push-button will flash on and off to indicate that Mute is
active. To unmute audio, press MUTE a second time, ad-
just the VOLUME Control, press an Input pushbutton or
press an Output pushbutton.
PH/AUX Inputs
When using a phono player with
a moving magnet cartridge con-
nected to the PH/AUX inputs,
set the PH-AUX switch to the
PH position. When using an
auxiliary program source com-
ponent connected to the PH/
AUX inputs, set the PH-AUX
switch to the AUX position. Re-
fer to figure 3.
Loud Switch
Press the LOUD push-button to add loudness bass compen-
sation to the volume control for improved low level listen-
ing.
Figure 1
Figure 3
Figure 2