Owner`s manual

11
How to Operate the C15 cont
Figure 4
Figure 5
Output 1 and 2
Press OUTPUT 1 or 2 push-buttons to send audio to sepa-
rate power ampli-
fiers connected to
the rear panel
OUTPUTS 1 or 2.
You can press ei-
ther push-button
individually or
both together. Re-
fer to figure 4.
Headphones Jack
Connect a pair of dynamic headphones to the Headphones
jack for private listening. Press Mute to mute all other out-
puts including the amplifier connected to the loudspeakers.
Refer to figure 4.
Reset of Microprocessors
In the event that the controls of the C15 stop functioning,
push the POWER switch OFF and wait about two minutes;
then push the POWER switch ON followed by pushing the
STANDBY/ON push-button. This will reset the C15 mi-
croprocessors and the Preamplifier should be functioning
normally.
Note: The above condition is usually caused by either
interruptions in AC power and/or major changes that
may occur in AC power line voltage.
Using a Signal Processor
When a signal processor is connected, set the rear panel
PROCESSOR switch to the IN
position. Refer to figure 5.
Note: When a signal processor is
connected and the C15
PROCESSOR Switch is set
to the IN position, the
processor must be on, or in
bypass mode, for a signal
to pass through the
preamplifier.
Figure 6
How To Make A Tape Recording
1. Select the source signal you wish to record with the
appropriate Front Panel or Remote Control Push-but-
ton. Refer to figure 6.
2. Adjust the record level using the tape recorder volume
control and proceed with the recording process.
3. To listen to the tape playback of the program source
just recorded, press the TAPE input push-button. Refer
to figure 6.
Note: The C15 TAPE OUTPUTS are not affected by the
VOLUME or BALANCE controls.