Owner`s manual
13
How to Operate the Remote Control
How to Operate the Remote Control
Mute
Press the MUTE push-button to mute audio in all LISTEN
outputs.
Mono
Press the MONO push-button to combine left and right ste-
reo signals to mono at all MAIN, AMPLIFIER, LISTEN
and HEADPHONES Outputs.
Audio
Press any of the eight Audio push-buttons to select a LIS-
TEN program source.
CD/Tape
Use these push-buttons to operate a CD player, CD changer
or tape recorder, when the component is connected to the
C100 with a McIntosh RCT Translator.
Numbered and +10 Push-buttons
Press push-buttons 0 through 9 to access tuner station pre-
sets, CD tracks or CD discs. When using a McIntosh
MCD7010 CD player, access track numbers higher than 10
by first pressing +10 and then a number push-button.
Disc and Track
Use the DISC and TRACK push-buttons when a CD player
or changer is being used.
Tuner Push-buttons
Use with a McIntosh tuner. Select AM or FM broadcast
band. Press and release SEEK Up or Down to move from
station to station. Press and hold a SEEK push-button to
move continuously from station to station. Press REVIEW
to start the automatic brief audition of each of the presets
stored in the tuner memory. Press REVIEW a second time
to stop on a station preset and exit the Review process.
Processors
Press the LISTEN PROCESSOR push-button to activate
rear panel processor connections to add signal processing
from an external processor to the LISTEN Outputs. Press
the RECORD PROCESSOR push-button to activate rear
panel connections to add signal processing from an exter-
nal processor to the RECORD outputs.
Record Monitor
Press the REC (Record) Monitor push-button to listen to
the signals being fed to the RECORD OUTPUTS.
Volume
Press the Up or Down VOLUME push-button to raise or
lower the listening volume level. The Record Outputs are
not affected.
Trim
Press TRIM to enter the Input Volume Level Trim mode.
Press a second time to exit the Trim mode.
Display
Press the DISPLAY push-button to cycle the Volume Dis-
play between dB and % of volume indications.
ACC ON - OFF
Press ACC ON or ACC OFF to turn power ON and OFF of
components that are connected with a McIntosh RCT
Translator - Repeater. Only the ACC ON push-button is
active with the McIntosh LV or DVD Disc Player.
NOTE: When other brands of components are connected with a
McIntosh RCT Translator, refer to the RCT Owners
Manual for further information on alternate remote
control push-button functions.