Owner`s manual

15
Auto Tone
The Auto Tone Feature activates the TONE BYPASS Dy-
namic Memory Circuit. When the Auto Tone Feature is set
to the On position, the C46 will automatically remember,
for each Input, whenever the Tone Bypass Circuit is On or
Off.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the BALANCE (Menu) Control until the words
AUTOTONE OFF appears.
3. Rotate the LISTEN Control until the Front Panel Al-
phanumeric Display indicates AUTOTONE ON. Refer
to figure 16.
4. Press the SETUP Push-button to exit the Setup Mode.
Setup, con’t
Remote Control Selection
The Remote Control included with the C46 utilizes the
NORMal McIntosh Control Codes. The Second Set of Con-
trol Codes the C46 will respond to is referred to as the
ALTernate Codes. The ALTernate Codes are for when the
C46 is used in the same location with another McIntosh
Control Center/Multichannel Processor/Decoder. This will
prevent the Remote Control from affecting the operation of
both units at the same time.
Note: If the ALT Remote Control Code is selected, the C46
will not respond using the supplied McIntosh Remote
Control.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the Front Panel BALANCE (Menu) Control un-
til the words REMOTE NORM appears.
3. Rotate the Front Panel LISTEN Control until the Front
Panel Alphanumeric Display indicates REMOTE ALT.
Refer to figure 17.
4. Press the SETUP Push-button to exit the Setup Mode.
Firmware Version
The C46 functionality is controlled by internal software that
is know as Firmware. The Version of the Firmware in the
C46 can be identified at any time by utilizing the Setup
Mode.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the Front Panel BALANCE (Menu) Control un-
til the word VERSION _. _ _ appears. Refer to figure
18.
3. The number after the word VERSION is the Firmware
number.
4. Press the SETUP Push-button to exit the Setup Mode.
The Volume Display Feature allows the Front Panel Alpha-
numeric Display to indicate the volume level either in Deci-
bels (dB) or as a Percentage of the total volume.
1. Press the SETUP Push-button to access the Setup
Mode.
2. Rotate the BALANCE (Menu) Control until the words
DISP PERCENT appears. Refer to figure 14.
3. Rotate the LISTEN Control until the Front Panel Al-
phanumeric Display indicates DISP DECIBEL. Refer
to figure 15.
4. Press the SETUP Push-button to exit the Setup Mode.
Volume Display
Figure 13
5. Press the SETUP Push-button to exit the Setup Mode.
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18