Owner`s manual

20
How To Make A Tape Recording
The separate RECORD and LISTEN Controls allow you to
make a tape recording from one program source while lis-
tening to another. You can also listen (monitor) to the re-
corded signal off the tape, a fraction of a second later, dur-
ing recording when a three head tape recorder is used. You
can also listen to the signal being fed to the tape recorder by
pressing the REC MONITOR Push-button. Refer to figure
28.
1. Select the desired program source to record with the
Front Panel RECORD Control.
2. Adjust the record level using the Recorder Volume Con-
trol.
3. To listen to the signal being fed to the recorder, press the
REC (Record) MONITOR Push-button.
4. To listen to the tape playback of the program source just
recorded, rotate the LISTEN Control to the desired in-
put.
Note: The C46 RECORD OUTPUTS are not affected by
the VOLUME or BALANCE controls. To listen to a
different program source while recording, rotate
the LISTEN Control to the desired source. The
recording process will not be affected and will
continue.
Reset of Microprocessors
In the event that the controls of the C46 stop functioning,
switch the POWER Switch to the Off Position and wait
Figure 28
about three minutes. Press the POWER Switch to the ON
position and press the STANDBY/ON Push-button. This
will reset the C46 microprocessors.
Note: The above condition is usually caused by either
interruptions in AC power and/or major changes in
voltage.
Default Settings
To restore the C46 to Factory Default Settings perform the
following. Press and hold the LISten Push-button together
with the OUTPUTS 2 Push-button. Refer to figure 28. Ap-
proximately 5 seconds after holding in the two Front Panel
Push-buttons together, the Front Panel Alphanumeric Dis-
play will indicate MASTER RESET. Refer to figure 29.
Release both Push-buttons and the Front Panel Alphanu-
meric Display will now indicate -- CLEARED - - and the
C46 will switch Off. Refer to figure 30.
Press the STANDBY/ON Push-button on the C46 and pro-
ceed to the Setup on page 13 to re-enter the custom settings
that have been previously made.
How to Operate the C46, con’t
Figure 29
Figure 30