Owners Manual

16
The second example will use selection of Trigger 2 to
activate when the BAL 1 Input is selected:
6. Rotate the INPUT Control to select “SETUP:
TRIGGER 3, Main” appears on the Display.
7. Rotate the VOLUME (ADJUST) Control to select
“SETUP: TRIGGER 2, Input” appears on the
Display. Refer to figure 33.
8. Press and hold in the INPUT Control until “SET-
UP: TRIGGER 2, Bal 1: OFF” appears on the
Display. Refer to figure 34.
9. Rotate the VOLUME (ADJUST) Control to select
“Bal 1: ON”. Refer to figure 35.
10. Exit the SETUP Mode by several presses of the
INPUT Control.
Power Control Triggers 1 and 2
By default the Power Control TRIGger 1 and TRIG-
ger 2 are assigned to activate when Output 1 or Output
2 is selected. Both Triggers can also be reassigned
to a given Input or Inputs or go On/Off with the C47
power.
In the first example, the Power Control Triggers 1
and 2 will be assigned to MAIN:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until “SETUP: Trig-
gers, (Hold INPUT)” appears on the Information
Display. Refer to figure 29.
3. Press and hold in the INPUT Control until
“SETUP: TRIGGER 1, Output 1” appears on the
Display. Refer to figure 30.
4. Rotate the VOLUME (ADJUST) Control to select
Main from the available additional selections in-
cluding Output 2 or Input. Refer to figure 31.
5. In a similar manner, perform steps 3 and 4 to
change the Trigger 2 setting from OUTPUT 2 to
Main. Refer to figure 32 and figure 31.
Figure 29
SETUP: Triggers
(Hold INPUT)
Figure 31
SETUP: TRIGGER 1
Main
Figure 30
SETUP: TRIGGER 1
Output 1
Figure 32
SETUP: TRIGGER 2
Output 2
Figure 33
SETUP: TRIGGER 2
Input
Figure 34
SETUP: TRIGGER 2
Bal 1: OFF
Figure 35
SETUP: TRIGGER 2
Bal 1: ON
Data Ports
Data Ports Connections between the C47 and a Mc-
Intosh Source Component allow for basic function
control of the source component using the C47 sup-
plied HR085 Remote Control. By default, all of the
four Data Ports are set to send the same Data to the
selected source. To dedicate a given Data Port for only
one source component (example, source component
connected to the BAL 1 Input will be assigned to Data
Port 1) perform the following Steps:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until “SETUP: Data
Ports, (Hold INPUT)” appears on the Information
Display. Refer to figure 36.
3. Press and hold in the INPUT Control until “SET-
UP: DATA PORT 1, All Data” appears on the
Display. Refer to figure 37.
4. Rotate the VOLUME (ADJUST) Control to select
“BAL 1” Input. Refer to figure 38.
5. In a similar manner, perform steps 3 and 4 to as-
sign any additional Data ports.
6. Exit the SETUP Mode by several presses of the
INPUT Control.
Figure 36
SETUP: Data Ports
(Hold INPUT)
Figure 37
SETUP: DATA PORT 1
All Data
Figure 38
SETUP: DATA PORT 1
BAL 1