Owners Manual

20
Volume Control
Rotate the Front Panel VOLUME Control or use the
VOLUME Upp or Downq Push-buttons on the Re-
mote Control for the desired listening level. Refer to
figures 60 and 63.
Trim Functions
The C47 has nine different Trim Selections with
Adjustments. The Trim Selections include Balance,
Input Trim Level, Treble, Bass, Mono/Stereo Mode,
Amplifier Meter Lights, Display Brightness, Phono
Cartridge (MC & MM) Loading (when the Input is
Selected) and when Headphones are connected HXD
Mode. The Trim Settings are stored in memory inde-
pendently for each Input Source Selected, except the
Meter Illumination and Display Brightness settings of
On or Off, which are the same for all inputs.
Note: Selection and Adjustment of all Trim Functions
may be performed by pressing the Front Panel
Power On and Off
The Red LED above the STANDBY/ON Push-button
lights to indicate the C47 is in Standby mode. To
switch ON the C47, press the STANDBY/ON Push-
button on the Front Panel or the (Power On)
Push-button on the Remote Control. The C47 will go
through a brief startup initialization with the Front
Panel Information Display indicating the last used
source and volume setting, this is followed by the
volume setting indication starting at zero and then
increasing to the last used volume setting. Refer to
figures 60, 61, 62 and 63. To switch OFF the C47 press
the STANDBY/ON Push-button on the Front Panel or
the OFF Push-button on the Remote Control.
Note: For an explanation of the Remote Control
Push-button functions, refer to pages 10 and 11.
Source Selection
Rotate the INPUT Control to select the desired source
or press the INPUT Upp or Downq Push-button on
the Remote Control. Refer to figures 60, 62 and 63.
INPUT Trim Control and
then rotating it to select the
desired Trim Function. Then
use the VOLUME Adjust
Control to change the set-
ting. Remote Control TRIM
Push-Button together with the
LEVEL UP / Down Push-
button may also be used.
Refer to figures 60 and 63.
BALANCE
Listening balance varies with
different program sources, room
acoustics and listening positions
relative to the Loudspeakers. Use
the Balance (Trim Function) as
needed to achieve approximately
equal listening volume levels in
each Loudspeaker. To adjust the
Balance perform the following:
1. Press the TRIM Push-button
repeatedly on the Remote
Control until “L BALANCE
R” appears on the Front Panel
Information Display. Refer to
figure 64.
Note: The Front Panel INPUT
Trim and VOLUME Adjust
Controls may also be used.
2. Press the LEVEL UP / DOWN
Push-buttons on the Remote
Control to emphasize the Right
Channel (refer to figure 65) or
How to Operate the C47
Figure 60
Fig ure 61
INPUT: BAL 1
15%
Figure 64
L BALANCE R
||
Figure 62
INPUT: MC PHONO
30%
Figure 63