Owners Manual

22
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
AMPLIFIER METER ILLUMINATION
The Meter Illumination of recent McIntosh Power
Amplifiers may be switched On or Off by performing
the following:
1. Select “AMP METER LIGHTS, On” as indicated
on the Front Panel Information Display. Refer to
figures 60, 63 (on page 20) and 80.
2. Switch Off the Meter Illumination. Refer to
figure 81.
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
Notes: 1. Control of Meter Illumination via the C47 for
recent McIntosh Power Amplifiers requires a
power control cable connection between the
Power Amplifier and C47.
2. Some A/V Processors will provide an On/Off
Control Signal when the C47 Passthru Input
Jack is connected to the A/V Processor via
the power control cable.
INFORMATION DISPLAY ILLUMINATION
The Brightness Level of C47 Front Panel Information
Display can be adjusted from bright to dim by per-
forming the following:
TONE CONTROL
With the Tone Controls Enabled (default setting), the
TRIM TREBLE and BASS Settings may be adjusted
for the currently selected Input Source. The LED
above the TONE Push-button will be illuminated.
When the Tone Controls are Disabled the previous
settings for Treble and Bass are bypassed from the
signal path. To deactivate Tone Controls perform the
following:
1. Select the desired Input Source.
2. Press the TRIM Push-button on the Remote Con-
trol until “TONE CONTROLS, Enabled” appears
on the Front Panel Display. Refer to figure 76.
3. Press TRIM LEVEL UP / DOWN Push-button to
activate the Tone Bypass. Refer to figure 77.
After approximately 6 seconds the Display returns to
indicate the Source Selection and Volume Level.
MONO/STEREO MODE
By default the Stereo Mode is active for all Input
Sources however, any Input Source may be assigned
to Mono Mode. To change Stereo Mode to Mono for a
given Input Source, perform the following steps:
Note: The audio signal present at the FIXED OUT
Jacks is affected by the Stereo/Mono setting.
1. Select the desired Input Source.
2. Select “MONO / STEREO,
______
” as
indicated on the Front Panel Information Display.
Refer to figure 78.
3. To select MONO Mode adjust the TRIM LEVEL.
Refer to figure 79.
Figure 60
How to Operate the C47, con’t
Figure 80
AMP METER LIGHTS
On
Figure 81
AMP METER LIGHTS
Off
Figure 79
MONO / STEREO
____
Figure 77
TONE CONTROLS
Disable
Figure 76
TONE CONTROLS
Enable
Figure 78
MONO / STEREO
______