Owner`s manual

15
4. Rotate the INPUT Control until “LEVEL: SRVR
_._” appears on the Front Panel Information
Display. The illustration in figure 10 indicates a
-2.5dB decrease in the SRVR Level to match the
volume level of the CD Input.
5. Repeat step 4 for other Inputs with component
sources connected until they all have the same
relative volume levels. Record any changes made
to the various inputs from the default settings
in the “Input and Power Control Settings” chart
below.
6. To exit from the Setup Mode, press the EQ BY-
PASS/SETUP Push-button.
The Front Panel Information Display Brightness may
be changed from the default setting. There are four
brightness settings for the Information Display. The
Display Brightness setting may be varied 1 (Dim) to
4 (Bright). Follow the steps below for reducing the
Display Brightness.
1. Press and hold the EQ BYPASS/SETUP Push-
button until the Setup Mode is active. Then press
the OUTPUT 2 / MENU ► Push-button until the
Setup Menu item “SETUP: DISPLAY” appears
on the Front Panel Information Display. Refer to
figure 11.
2. Rotate the VOLUME/ADJUST Control until
“BRIGHTNESS: 1” appears on the Front Panel
Information Display. Refer to figure 12.
3. To exit from the Setup Mode, press the EQ BY-
PASS/SETUP Push-button.
Setup, con’t
Display Brightness
Figure 11
SETUP: DISPLAY
BRIGHTNESS: 3
Input and Power Control Settings
Input Name
Connection
Type
New Level
(Trim)
Triggers
1 2
TUNER
CD
CD2
DVD
AUX
SRVR (Rec)
PHONO MC
PHONO MM
Figure 10
LEVEL: SRVR -2.5dB
Min Max
¦
¦
¦ ¦
Figure 12
SETUP: DISPLAY
BRIGHTNESS: 1
Passthru
SETUP: PASSTHRU
Source: OFF
Figure 13
The C48 can be part of a Multichannel Sound System
for SACD, DVD-Audio and Home Theater. The Right
and Left Front Channels from an Audio/Video Control
Center or Surround Decoder can “Passthru” the C48
and onto its associated Power Amplifier(s). The Setup
Mode allows the activation of the Passthru Mode and
the selection of the specified C48 Input Connector to
be used for the Right and Left Front Channels. In the
example below, the Right and Left Front Channels
from the Audio/Video Control Center will be connect-
ed to the BALanced 2 Input Connectors on the C48.
Refer to page 9 for additional connection information.
Notes: 1. The Phono Input Connectors and Digital Input
Connectors are not assignable as a Passthru
Input.
2. If Balanced Input Connectors 1 and/or 2 are
already reassigned to a given Input, they will
not appear in the list of available Inputs for the
Passthru Mode.
3. When one of the RCA Inputs is selected as a
Passthru Input, it is advisable to remove it
from the list of available Inputs by switching
it Off. Refer to “Source Inputs Reassignment”
starting on page 13.
1. Press and hold the EQ BYPASS/SETUP Push-
button until the Setup Mode is active. Then press
the OUTPUT 2 / MENU ► Push-button until the
Setup Menu item “SETUP: PASSTHRU, Source:
OFF” appears on the Front Panel Alphanumeric
Display. Refer to figure 13.
2. Rotate the VOLUME/ADJUST Control until
“SETUP: PASSTHRU, Source: BALANCED 2”