Owner`s manual

17
C. Press the 3, 2, 4, 2 and 9 Push-buttons within 5
seconds.
D. The “Mc” Push-button flashes twice.
Note: To reset the Remote Control to normal
codes perform steps A and B then enter
3, 2, 4, 2 and 8 for step C.
5. Press the VOLUME UP/DOWN Push-button on
the Remote Control to verify proper operation.
The C48 may be remotely controlled from other
equipment connected to the Rear Panel RS232C con-
nector. The speed at which the C48 communicates
(8 bit, no parity and 1 stop bit) with other equipment
is adjustable from 9,600 bits per second to 115,200
bits per second. To change from the default speed of
115,200 bits per second, perform the following steps:
1. Press and hold the EQ BYPASS/SETUP Push-
button until the Setup Mode is active. Then press
the OUTPUT 2 / MENU ► Push-button until the
Setup Menu item “SETUP: COMM PORT BAUD
RATE: 115200” appears on the Front Panel Infor-
mation Display. Refer to figure 20.
2. Rotate the VOLUME/ADJUST Control to select
the desired speed.
3. Press the EQ BYPASS/SETUP Push-button to
exit the Setup Mode.
Setup, con’t
Remote Control Codes
The Remote Control included with the C48 utilizes the
NORMal McIntosh Control Codes. The Second Set of
Control Codes the C48 will respond to is referred to as
the ALTernate Codes. The ALTernate Codes are used
when the C48 is used in the same location as another
McIntosh Preamplifier and/or A/V Control Center.
This will prevent the Remote Control from affecting
the operation of both units at the same time. To acti-
vate the Remote Control ALTernate Codes perform
the following steps:
1. Press and hold the EQ BYPASS/SETUP Push-
button until the Setup Mode is active. Then press
the OUTPUT 2 / MENU ► Push-button until the
Setup Menu item “SETUP: REMOTE, CODES:
NORM” appears on the Front Panel Information
Display. Refer to figure 21.
2. Rotate the VOLUME/ADJUST Control until
“CODES: ALT” appears on the Front Panel Infor-
mation Display. Refer to figure 22.
3. Press the EQ BYPASS/SETUP Push-button to
exit the Setup Mode.
4. To change the C48 Remote Control to the Alter-
nate Codes perform the following steps:
A. Press the “Mc” Push-button.
B. Press the SET Push-button until the “Mc” Push-
button flashes twice.
Comm Port Baud Rate
Figure 20
SETUP: COMM PORT
BAUD RATE: 115200
Figure 21
SETUP: REMOTE
CODES: NORM
Figure 22
SETUP: REMOTE
CODES: ALT