Owner`s manual

20
After approximately 4 seconds
the Alphanumeric Display
returns to indicate the Source
Selection and Volume Level.
Mono
Press the Front Panel MONO
Push-button to change from
Stereo to Mono Mode for
the currently selected Input
Source. The LED above the
MONO Push-button will il-
luminate. Refer to figure 50.
The C48 remembers for each
selected Input whether the
Mode is Stereo or Mono. To
change the Mode from Mono
to Stereo for the currently
selected Input Source press the
MONO Push-button.
Note: The audio signal
present at the RE-
CORD OUT Jacks
is unaffected by the
MONO Push-button.
Equalizer Bypass
Press the Front Panel EQ
BYPASS Push-button to
remove the C48 Equalizer
Circuitry from the signal path
for the currently selected Input
Source. The LED above the
EQ BYPASS Push-button will illuminate. Refer to
figure 50. The C48 remembers for each selected Input
whether the Equalizer Circuitry is deactivated. To re-
1. Select the desired Input Source.
2. Select “MONO/STEREO MODE, ______: Ste-
reo” as indicated on the Front Panel Information
Display. Refer to figure 63.
3. Set the “MONO/STEREO MODE” for either STE-
REO or MONO. Refer to figure 64.
After approximately 4 seconds the Information
Display returns to indicate the Source Selection and
Volume Level.
DIGITAL AUDIO DISPLAY
By default the Digital Audio Display is switched Off.
To display information about the type of digital signal
present when any one of the five digital inputs is se-
lected, perform the following steps:
1. Select one of the Inputs assigned to an active digital
source.
Note: The USB-D/A Input may also be selected when
the C48 is connected to a computer.
2. Select “DIGITAL AUDIO, Display Info: Off” as
indicated on the Front Panel Information Display.
Refer to figure 65.
3. Set the “DIGITAL AUDIO, Display Info” to On.
Refer to figure 66.
After approximately 4 seconds the Information
Display will return to indicate the Source Selection,
Volume Level and the Digital Information. Refer to
figure 67.
PHONO ADJUSTMENTS
When the Phono MC or Phono MM Input is selected
an additional TRIM SELECT FUNCTION becomes
available for adjustment. Perform the following steps
to make the Phono Trim Adjustments:
1. Select either the Phono MM or Phono MC Source
Input.
2. Select “PHONO CARTRIDGE, Moving Coil 500
Ohm” or “PHONO CARTRIDGE, Moving Mag-
net 50pF” as indicated on the Front Panel Informa-
tion Display. Refer to figures 68 and 69.
3. Set the desired phono cartridge loading value
(Ohms for a Moving Coil Cartridge or Capaci-
tance for a Moving Magnet Cartridge) that comes
closest to the Phono Cartridge Makers recom-
mended value.
How to Operate the C48, con’t
Figure 63
MONO / STEREO MODE
TUNER : Stereo
Figure 64
MONO / STEREO MODE
TUNER : Mono
Figure 65
DIGITAL AUDIO
Display Info : Off
Figure 66
DIGITAL AUDIO
Display Info : On
Figure 67
SOURCE: DVD
15% 2CH PCM
Figure 53
Figure 68
PHONO CARTRIDGE
Moving Coil: 500 Ohm
Figure 69
PHONO CARTRIDGE
Moving Magnet: 50pF