Owner`s manual

22
Power
Press the Power push-button and the Zone will turn-on
with either the default or programmed signal source and
volume level. Press the Power push-button a second time
to turn the Zone OFF.
Note: Operations in remote Zones can be performed by
pressing a push-button on a keypad or remote control.
Refer to figures 4 and 5. The Remote Control Push-
buttons that are highlighted in white are for use with
other McIntosh Control Centers.
Source Selection
Select and operate any available signal
source by pressing the appropriate Key-
pad or Remote Control Push-button.
Volume
The Turn-On Volume Level can be
changed by pressing an UP p or DOWN
q Volume Push-button.
System Off
Normally remote Zones are turned On
and Off individually in each respective
Zone by pressing the Power Push-button
on a Keypad or Remote Control. If you
desire to turn off the entire McIntosh Au-
dio/Video System you can press the SYS
Off Push-button.
Note: Individual Remote Zones should
normally be turned Off with the Power Push-button
since there may be other Zones in use that would
automatically be turned Off by the Sys OFF Push-
button in a Specific Zone.
Dedicated Zone Source Components
If a specific CR16 Zone has a Source Component dedi-
cated exclusively to that Zone, it can be operated with a
How to Operate in Remote Zones
Introduction to Programming
The default setting for each Zone is to turn-on with the
Tuner as the Source and a Volume Level of 20. You can
change the default setting to any of CR16 Inputs at the de-
sired volume level. It is also possible to have a Zone turn-
on with the Last Selected Source and Volume Level Set-
ting. A Power-On and Play Command can also programed
for a compatible source component so that it occurs when
the Zone is first turned-on. It is also possible to prevent the
Control of a Selected Source for a given Zone yet allow
listening and/or viewing of that source. All programming is
stored in permanent memory and is retained until changed,
even in the event of a power failure. Refer to figure 6.
Note: In order to Program a Zone for any function, it first
must be switched OFF.
Setting the same source and volume level
1. Press the Program Push-button for the Zone you wish to
program. The LED next to the selected Zone will turn-
on with a constant indication.
Note: After pressing a Program push-button, you must make
any changes with 10 seconds of each other. After the 10
seconds, the programming for that Zone will turn Off.
2. Select a Source for that Zone by pressing any of the
eight Source Push-buttons and the selected source front
panel LED will turn-on. This will become the active
Source whenever that Zone is first turned-on.
3. Press an Up p or Down Volume q Push-button to se-
lect the desired volume level in that Zone. The Front
Panel Display will indicate the selected level.
4. Press Program Push-button again or wait 10 seconds to
exit the programming mode.
Setting the last selected source and volume level
1. Press the Program Push-button for the Zone you wish to
program. The LED next to the selected Zone will turn-
on with a constant indication.
Note: After pressing a Program Push-button, you must make
any changes within 10 seconds of each other. After the
10 seconds, the programming for that Zone
programming will turn Off.
Figure 4
Figure 5
Keypad or Remote Control. When a dedicated Zone Source
Component is connected, it replaces the source component
that is connected to the CR16 Aux Input. If the CR16 is
connected with a Control Center which has a Source Com-
ponent connected to its Aux Input, that component will not
be available in the Zone with the Dedicated Source Com-
ponent.