Owner`s manual

23
How to Operate in Remote Zones and Program the CR16
2. Press the Source Push-button, whose LED is currently
illuminated. The entire row of Front Panel Source
LEDs for that Zone will turn-off.
3. Press Program Push-button again or wait 10 seconds to
exit the programming mode. The next time that Zone is
turned-on it will come on with the last selected source
and volume level.
Accessory Power On or Off
1. Press the Program Push-button for the Zone requiring
the Accessory Control On Function.
2. Press Accessory Control On to program a turn on sig-
nal. The LED next to the Accessory On Push-button
will Turn-On to indicate accessory on command has
been selected.
3. Press Program Push-button again or wait 10 seconds to
exit the programming mode.
Note: If the Acessory Control is already on just repeat the
above procedures to turn off the feature. The accessory
source component must have a Data cable
interconnected with the CR16 in order to receive the
turn-on command and must also have a power switch
that automatically cycles off when AC power is
removed.
Transport Play
1. Press the Program Push-button for the Zone requiring a
Transport Play Command.
2. Press the Source Push-button that requires the Transport
Play Command.
3. Press the Transport Play Push-button. The LED next to
the Transport Play Push-button will Turn-On to indi-
cate the Transport Play Command has been selected.
Note: If Accessory Power On is used in combination with
Transport Play Command there is a 2 second time delay between
the two commands.
4. Press Program Push-button again or wait 10 seconds to
exit the programming mode.
Accessory Control Off
1. Press the Program Push-button for the Zone requiring
Accessory Control Off.
2. Press the Accessory Control Off Push-button. The Red
LED to the right of the Accessory Control Off Push-
button will turn ON to indicate that the Control func-
tion is Turned OFF for that Zone.
3. Press Program Push-button again or wait 10 seconds to
exit the Programming Mode.
Programming with a Keypad or Remote Control
1. Press the Source Push-button for the desired new
Source.
2. Press an Up p or Down qVolume Push-button to se-
lect the desired volume level in that Zone.
3. Press and hold the new Source Push-button for 3 sec-
onds. The zone audio will mute, indicating that the
change has occurred. Release the push-button to
unmute. The next time that Zone is turned on, the new
signal source and volume level will be in effect.
Figure 6