Owner`s manual

25
How to Operate the Remote Control
The supplied remote control is capable of directly control-
ling the functions of contemporary McIntosh Source Com-
ponents connected to the CR16. Earlier McIntosh source
components and other brand source components can be
controlled by the CR16 with the addition of a McIntosh
Remote Control Translator (RCT).
Note: Your McIntosh Dealer can assist you with the
installation and operation of the Remote Control
Translator (RCT).
Mute
Press the MUTE push-button to mute audio at the active
Zone.
Input Source Selection
Press any of the eight input push-buttons to select a Audio/
Video Source.
CD/Tape Functions
Use these push-buttons to operate a CD player, CD changer
or tape recorder.
Numbered Push-buttons
Press push-buttons 0 through 9 to access tuner station pre-
sets or CD tracks/discs.
Disc and Track
Use the DISC and TRACK push-buttons when a CD player
or changer is being used.
Tuner Push-buttons
Press the AM or FM push-button to select the desired
broadcast band. Press and release the Channel Upp or
Downqpush-button to move from station to station. Press
and hold a Channel Upp or Downq push-button to move
continuously from station to station. Press REVIEW Push-
button to start the automatic brief audition of each of the
presets stored in the tuner memory. Press REVIEW a sec-
ond time to stop on a station preset and exit the review pro-
cess.
Volume
Press the Up or Down VOLUME push-button to raise or
lower the listening volume level.
Acc On
Press ACC ON to turn the power ON to a McIntosh Disc
Player.
Acc Off
Press ACC OFF to turn the power OFF to a McIntosh Disc
Player.
E
Press E to perform various functions on a variety of McIn-
tosh Components. It will also pause the playing of a disc or
tape player.
Lighting
Press and release the LIGHTING push-button to momen-
tarily illuminate the upper half of the remote control push-
buttons.
Note: While the LIGHTING push-button is being depressed,
the remote control will be unable to send a remote
command. When the LIGHTING push-button is
released, the push-buttons will continue to stay
illuminated for approximately three seconds thus
allowing you to send the desired command.