Owner`s manual

Installation

The MSE1 can be placed upright on a table or shelf, stand-

ing on its four feet. It also can be custom installed in a

piece of furniture or cabinet of your choice. The required

panel cutout, ventilation cutout and unit dimensions are

shown.

Always provide adequate ventilation for your MSE1.

Cool operation ensures the longest possible operating life

for any electronic instrument. Do not install the MSE1 di-

rectly above a heat generating component such as a high

powered amplifier. If all the components are installed in a

single cabinet, a quiet running ventilation fan can be a defi-

nite asset in maintaining all the system components at the

coolest possible operating temperature.

A custom cabi-

net installation

should provide the

following minimum

spacing dimensions

for cool operation.

Allow at least 2

inches (5.08 cm)

above the top, 2

inches (5.08cm) be-

low the bottom and

1 inch (2.54 cm) on

each side of the

Surround Expander,

so that airflow is

not obstructed. Al-

low 20 inches (50.8

cm) depth behind

the front panel. Al-

low 1 inch (2.54

cm) in front of the

mounting panel for

clearance. Be sure

to cut out a ventila-

tion hole in the

mounting shelf ac-

cording to the di-

mensions in the

drawing.

Installation