Owner`s manual

19
How to Operate by Remote Control
The supplied Remote Control is capable of directly control-
ling the functions of contemporary McIntosh Source Com-
ponents connected to the MA2275. Earlier McIntosh
source components and other brand source components can
be controlled by the MA2275 with the addition of a McIn-
tosh Remote Control Translator (RCT).
Note: Your McIntosh Dealer can assist you with the
installation and operation of the Remote Control
Translator (RCT).
Mute
Press the MUTE Push-button to mute audio at the Loud-
speaker and Headphone Outputs. Press MUTE a second
time to unmute audio.
Mode
Press the MODE Push-button to select between Stereo and
Mono Modes of operation.
Input Source Selection
Press one of the Input Push-buttons to select the desired
program source.
Disc/Tape Functions
Use these push-buttons to operate a Disc Player or Tape
Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre-
sets or Disc chapters/tracks/discs.
Disc and Track
Use the DISC and TRACK Push-buttons when a Disc
Players is being used.
Note: Certain Disc Players will require a Numbered Push-
button be pressed immediately after the Disc or Track
Push-button is depressed.
Volume
Press the UpS or DownT VOLUME Push-button to raise
or lower the listening volume level.
Note: The TAPE OUPUTS are not affected by volume
changes.
Acc On/Acc Off
Press ACC ON to turn the power ON to certain McIntosh
Disc Players. Press ACC OFF to turn the power OFF to
certain McIntosh Disc Players. The ACC ON/OFF Push-
buttons also control the signal at the ACCessory(B) Power
Control Jack; it will also remember the last command when
the MA2275 is switched Off and On again.
E
Press E to perform various functions on a variety of
McIntosh Components. It will also pause the playing of a
Disc or Tape playback.
Lighting
Press and release the LIGHTING Push-button to momen-
tarily illuminate the upper half of the Remote Control
Push-buttons.
Note: While the LIGHTING Push-button is being depressed
the Remote Control will be unable to send a remote
command. When the LIGHTING Push-button is released
the push-buttons will continue to stay illuminated for
approximately three seconds thus allowing you to send
the desired command.
How to Operate by Remote Control