Owner's Manual

24
present when any one of the three digital inputs is
selected, perform the following steps:
1. Select one of the Inputs assigned to an active digital
source.
Note: The USB-D/A Input may also be selected when
the MA5200 is connected to a computer.
2. Press the TRIM Push-button on the Remote Con-
trol until “DIGITAL AUDIO, Display Info: On”
is indicated on the Front Panel Display. Refer to
figure 64.
3. If it is not desirable to display the information, use
the TRIM LEVEL + / - Push-button to switch it
Off. Refer to figure 65.
After approximately 5 seconds the Display will return
to indicate the Source Selection and Volume Level.
METER BACKLIGHT
The MA5200 Front Panel Meter Illumination may be
switched On or Off by performing the following:
1. Press the TRIM Push-button on the Remote
Control until “METER BACKLIGHT, Lights:
On” appears on the Front Panel Display. Refer to
figure 66.
2. Press TRIM LEVEL + / - Push-button to switch
Off the Meter Illumination. Refer to figure 67.
each preference there are four brightness settings for
the Display. The Display Brightness setting may be
YDULHG'LPWR%ULJKW)ROORZWKHVWHSVEHORZ
for reducing the Display Brightness (with the Meter
,OOXPLQDWLRQ2Q
1. Press the TRIM Push-button on the Remote Con-
trol until “DISPLAY, Bightness: 3” appears on the
Front Panel Display. Refer to figure 63.
2. Press TRIM LEVEL + / - Push-button to select the
desired Brightness.
Note: To change the Display Brightness preference
with Meter Backlight Off, first switch Off the
Meter Backlight on this page and then change
the Display Brightness Setting.
After approximately 5 seconds the Display returns to
indicate the Source Selection and Volume Level.
DIGITAL AUDIO DISPLAY
By default the Digital Audio Display is switched Off.
To display information about the type of digital signal
1. Select the desired Input by using the direct access
Input Push-button on the Remote Control.
2. Press the TRIM Push-button on the Remote Con-
trol until “MONO/STEREO MODE, _ _ _ _ _ _ :
Stereo” appears on the Front Panel Display. Refer
to figure 61.
3. Press TRIM LEVEL + / - Push-button to select the
MONO Mode. Refer to figure 62.
After approximately 5 seconds the Display returns to
indicate the Source Selection and Volume Level.
DISPLAY BRIGHTNESS
The Front Panel Display Brightness may be changed
from the default setting. The MA5200 will remem-
ber two brightness preferences, one with the Meters
Illuminated and one without Meter Illumination. For
Figure 50
How to Operate the MA5200, con’t
Figure 63
DISPLAY
Brightness: 3
Figure 64
DIGITAL AUDIO
Display Info : On
Figure 65
DIGITAL AUDIO
Display Info : Off
Figure 66
METER BACKLIGHT
Lights: On
Figure 61
MONO / STEREO MODE
TUNER : Stereo
Figure 62
MONO / STEREO MODE
TUNER : Mono