Owner's Manual

General Specications
Power Control and Trigger Output
12VDC, 25mA
Power Requirements
Field AC Voltage conversion of the MA9500 is not possible.
The MA9500 is factory configured for one of the following AC
Voltages:
100 Volts, 50/60Hz at 8.0 amps
110 Volts, 50/60Hz at 6.6 amps
120 Volts, 50/60Hz at 6.6 amps
127 Volts, 50/60Hz at 6.6 Amps
220 Volts, 50/60Hz at 3.6 amps
230 Volts, 50/60Hz at 3.3 amps
240 Volts, 50/60Hz at 3.3 amps
Standby: Less than 0.25 watt
Note: Refer to the rear panel of the MA9500 for the correct
voltage.
Overall Dimensions
Width is 17-1/2 inches (44.45cm)
Height is 9-7/16 inches (24.0cm) including feet
Depth is 19-3/4 inches (50.16cm) including the Front Panel and
Knobs
Weight
101 pounds (45.8 kg) net, 134 pounds (60.8 kg) in shipping carton
Shipping Carton Dimensions
Width is 29-1/2 inches (74.93cm)
Depth is 29 inches (73.66cm)
Height is 17 inches (43.18cm)
MA9500 Packing Material ListPacking Instructions
In the event it is necessary to repack the equipment for shipment,
the equipment must be packed exactly as shown below. It is very
important that the four plastic feet are attached to the bottom of
the equipment. Two 1/4-20 x 2-1/4 inch screws and washers must
be used to fasten the unit securely to the bottom pad and wood
skid. This will ensure the proper equipment location on the bot-
tom pad. Failure to do this will result in shipping damage.
Use the original shipping carton and interior parts only if they are
all in good serviceable condition. If a shipping carton or any of
the interior part(s) are needed, please call or write Customer Ser-
vice Department of McIntosh Laboratory. Refer to Page 3. Please
see the Part List for the correct part numbers.
Quantity Part Number Description
1 034052 Shipping carton top
1 034051 Shipping carton bottom
2 034186 Front and rear foam pad
2 034187 Side foam pad
2 034054 Top and bottom foam pad
1 034136 Inner carton top
1 034137 Inner carton bottom
1 034188 Inner foam pad
1 034479 Shipping skid
4 401212 1/4-20 hex cap x 2-1/4 inch
screw
2 104058 1/4 inch flat washer 1-1/2
inch
4 017937 Plastic foot
4 404080 #10 flat washer
BOTTOM PAD
PLASTIC FOOT
SPACER (4)
#10 X 2-1/2”
SCREW (2)
PLASTIC FOOT
SPACERS (2)
#10-32 X 3/4
MACHINE SCREW
WITH WASHER (4)
#10 X 1 3/4
FLAT WASHER
SHIPPING
CARTON
END C
AP (4)
INNER
CARTON
TOP PAD
INNER
CARTON
WOOD SKID
UNIT WITH
(4) FEET ON
BOTTOM COVER
IMPORTANT
(Read Above)
IMPORTANT
(Read Above)