Owner's Manual

16
The MA/MAC6700’s Power Amplifier, together with
an additional separate Power Amplifier, may be used
to Bi-Amplify a Loudspeaker System. In the illustra-
tion on this page the Power Amplifier of the MA/
MAC6700 is connected to the Midrange/High Fre-
quency Section of the Loudspeaker. The additional
separate Power Amplifier is connected to the Low
Frequency Section of the Loudspeaker System.
Warning: The Loudspeaker System used for
Bi-Amplification must have the
jumpers removed from between the
MID/HIGH and LOW Frequency
Sections of the Loudspeaker System.
Failure to remove them could result
in damage to the MA/MAC6700 and/
or the separate Power Amplifier.
MA/MAC6700 Connections:
1. Remove the “McIntosh Jumpers” from between
the OUTPUT 1 Jacks and the PWR AMP In Jacks
located on the Rear Panel of the MA/MAC6700.
Note: Place the “McIntosh Jumper” in a safe place
for possible future use.
2. Using a pair of shielded RCA Type Audio “Y”
Adapters connect the OUTPUT 1 Jacks to the
PWR AMP In Jacks, for both Left and Right
Channels.
3. Connect the remaining unconnected part of the
“Y” Adapters to the separate Power Amplifier.
4. Refering to the Loudspeaker Connection Instruc-
tions on page 14, and in the Owner’s Manual sup-
plied with the Power Amplifier and Loudspeaker,
connect the MA/MAC6700 Output Terminals to
the Loudspeaker MID/HIGH Input Terminals.
Note: The Loudspeaker Connection illustrations
on this page are for the Left Channel. Con-
nect the Right Channel Loudspeaker in the
same manner.
MA6700 / MAC6700
Connecting for Bi-Amplification
Connecting for Bi-Amplification
+
-
Left Channel
Loudspeaker
“Y” adapter Cable
3RZHU$PSOL¿HU