Owner's Manual

26
The MA/MAC6700 incorporates an Auto Off Feature,
which automatically places the preamplifier into the
Power Saving Standby/Off Mode. This occurs approx-
imately 30 minutes after there has been an absence of
audible audio signals on the selected input (on either
FKDQQHORUXVHUDFWLYLW\LQFOXGHVFKDQJHVWRDQ\
of the Operation Functions such as source selection,
YROXPHDGMXVWPHQWHWF,ILWLVGHVLUDEOHWRGLVDEOHWKH
Auto Off Feature perform the following steps:
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Setup Mode is
active. Then rotate the INPUT CONTROL until
the Setup Menu item “SETUP: POWER MODE,
Auto Off: Enabled” appears on the Front Panel
Display. Refer to figure 29.
2. Rotate the VOLUME Control until “SETUP:
POWER MODE, Auto Off: Disabled” appears on
the Front Panel Display. Refer to figure 30.
The Remote Control included with the MA/MAC6700
utilizes the NORMal McIntosh Control Codes. The
Second Set of Control Codes the MA/MAC6700 will
respond to is referred to as the ALTernate Codes.
When the MA/MAC6700 is used in the same location
as another McIntosh Preamplifier and/or A/V Control
Center, the ALTernate Codes are used. This will pre-
vent the Remote Control from affecting the operation
of both units at the same time. To activate the Remote
Control ALTernate Codes perform the following steps:
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Setup Mode
is active. Then rotate the INPUT CONTROL
until the Setup Menu item “SETUP: REMOTE,
CODES: NORM” appears on the Front Panel
Display. Refer to figure 27.
2. Rotate the VOLUME Control to select “SETUP:
REMOTE, CODES: ALT”. Refer to figure 28
3. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will
revert back to its normal display.
4. To change the MA/MAC6700 Remote Control to
the Alternate Codes perform the following steps:
A. Press the “Mc” Push-button.
B. Press the SET Push-button until the “Mc” Push-
button flashes twice.
C. Press the 3, 2, 4, 2 and 9 Push-buttons within 5
seconds.
D. The “Mc” Push-button flashes twice.
Note: To reset the Remote Control to normal
codes perform steps A and B then enter
3, 2, 4, 2 and 8 for step C.
5. Press the VOLUME UP/DOWN Push-button on
the Remote Control to verify proper operation.
Remote Control Codes
Figure 27
SETUP: REMOTE
CODES: NORM
Figure 28
SETUP: REMOTE
CODES: ALT
Power Mode
Figure 29
SETUP: POWER MODE
Auto Off: Enabled
Figure 30
SETUP: POWER MODE
Auto Off: Disabled
3. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will revert
back to its normal display.