Owner's Manual

27
The TM2 AM/FM Tuner has three different Tuning
Modes when installed into the MA/MAC6700. One
of the Tuning Modes is Preset Tuning, where favor-
ite stations are entered into memory for quick recall.
Any preset station may be removed from memory at
any time. There are times when it may be desirable
to remove from memory all the preset stations. To ac-
complish this perform the following steps:
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Setup Mode
is active. Then rotate the INPUT CONTROL
until the Setup Menu item “SETUP: TUNER,
Clear Presets: None” is indicated. Refer to figure
TM2-3.
2. Rotate the VOLUME Control to select one of four
choices. Refer to figures TM2-4 thru TM2-6.
121(GHIDXOWVHWWLQJ1R3UHVHWVDUHFOHDUHG
$0DOO$0VWRUHG3UHVHWVDUHFOHDUHG
)0DOO)0VWRUHG3UHVHWVDUHFOHDUHG
All (all AM and FM stored Presets are
FOHDUHG
Setup, con’t
Your McIntosh MA/MAC6700 with the TM2 Tuner
Module installed has been factory configured for
default operating settings that will allow immediate
enjoyment of superb audio from AM/FM and HD
Radio
TM
Stations without the need for further adjust-
ments. Proceed to “Operating the TM2 and TM3 Tun-
er Module” on page 39 at this time, unless you wish to
make changes to the TM2 factory default settings.
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Setup Mode is
active. Then rotate the INPUT CONTROL until
the Setup Menu item “SETUP: TUNER SDK,
MC__._.________” firmware version. Refer to
figure TM2-1.
2. Rotate the INPUT Control until the Front Panel
Display indicates “SETUP: TUNER DSP, DRI-
___-_______-___” firmware version. Refer to
figure TM2-2.
These firmware version numbers identify the type of
operation functions of the TM2 Tuner Model.
3. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will revert
back to its normal display.
TM2 Tuner Module Clear Presets
Figure TM2-1
SETUP: TUNER SDK
MC . _
Figure TM2-2
SETUP: TUNER DSP
DRI- - -
TM2 Tuner Module Firmware Version
Figure TM2-3
SETUP: TUNER
CLEAR PRESETS: NONE
Figure TM2-4
SETUP: TUNER
CLEAR PRESETS: AM
Figure TM2-5
SETUP: TUNER
CLEAR PRESETS: FM
Figure TM2-6
SETUP: TUNER
CLEAR PRESETS: ALL
3. After the “Clear Presets” choice has been selected
1RQH$0)0RU$//WKHFKDQJHWRWKH
stored presets will occur when the SETUP Mode
has been exited in the next step.
4. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will
revert back to its normal display.