Owner's Manual
Table Of Contents
- Owners Manual
- Rear Panel Connections
- Tuner Module Installation and Connecting Antennas
- Connection Diagrams
- Remote Control Owners Manual
- Preferred Settings for Use with a PC
- Spec Sheet
- Warranty
28
The TM3 AM/FM Tuner has three different Tuning
Modes when installed into the MA/MAC6700. One
of the Tuning Modes is Preset Tuning, where favor-
ite stations are entered into memory for quick recall.
Any preset station may be removed from memory at
any time. There are times when it may be desirable
to remove from memory all the preset stations. To ac-
complish this perform the following steps:
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Setup Mode
is active. Then rotate the INPUT CONTROL
until the Setup Menu item “SETUP: TUNER,
Clear Presets: None” is indicated. Refer to
figure TM3-2.
2. Rotate the VOLUME Control to select one of four
choices. Refer to figures TM3-3 thru TM3-5.
121(GHIDXOWVHWWLQJ1R3UHVHWVDUHFOHDUHG
$0DOO$0VWRUHG3UHVHWVDUHFOHDUHG
)0DOO)0VWRUHG3UHVHWVDUHFOHDUHG
All (all AM and FM stored Presets are
FOHDUHG
Your McIntosh MA/MAC6700 with the TM3 Tuner
Module installed has been factory configured for
default operating settings that will allow immediate
enjoyment of superb audio from AM and FM Stations
without the need for further adjustments. Proceed to
“Operating the TM2 and TM3 Tuner Module” on page
39 at this time, unless you wish to make changes to
the TM3 factory default settings.
1. Press and hold the INPUT CONTROL until the
Front Panel Display indicates the Setup Mode is
active. Then rotate the INPUT CONTROL until
the Setup Menu item “SETUP: TUNER VER,
TM3_______” firmware version. Refer to figure
TM3-1.
The firmware version number identifies the type of
operation function of the TM3 Tuner Model.
2. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will revert
back to its normal display.
TM3 Tuner Module Clear PresetsTM3 Tuner Module Firmware Version
Figure TM3-2
SETUP: TUNER
CLEAR PRESETS: NONE
Figure TM3-3
SETUP: TUNER
CLEAR PRESETS: AM
Figure TM3-4
SETUP: TUNER
CLEAR PRESETS: FM
Figure TM3-5
SETUP: TUNER
CLEAR PRESETS: ALL
3. After the “Clear Presets” choice has been selected
1RQH$0)0RU$//WKHFKDQJHWRWKH
stored presets will occur when the SETUP Mode
has been exited in the next step.
4. To exit from the Setup Mode, press the INPUT
CONTROL and the Front Panel Display will
revert back to its normal display.
Figure TM3-1
SETUP: TUNER VER
TM3_ _ _ _ _ _ _ _