Owner's Manual

36
the MA/MAC6700 has returned to a safe operating
temperature, normal operation will resume.
+RZ7R0DNHD5HFRUGLQJ
1. Select the desired signal source you wish to record
by using the Front Panel INPUT Control or the
appropriate Source Push-button on the Remote
Control.
2. Adjust the record level using the recorder volume
control and proceed with the recording process.
3. To listen to the playback of the program source just
recorded select the SERVER Input.
Note: The MA/MAC6700 REC OUTPUTS are not
affected by the VOLUME, BALANCE or TONE
Control Settings.
Using a Separate Power Amplifier
There are two different ways to use a separate power
amplifier with a MA/MAC6700. The first way is
to use the separate amplifier instead of the MA/
MAC6700 built-in Power Amplifier. Connect the
Loudspeakers to the separate power amplifier and re-
move the McIntosh
Jumpers that are
located between
the OUTPUTS
1 Jacks and the
PWR AMP IN-
PUT Jacks. Refer
to figure 85.
Note: The McIntosh Jumpers must be connected, be-
tween the above mentioned jacks, when the MA/
MAC6700 Internal Power Amplifier is to be used.
The second way is to use both a separate power
amplifier and the MA/MAC6700 built-in Power
Amplifier. Connect one pair of Loudspeakers to the
accuracy of at least 95% of the power output with only
a single cycle of a 2,000Hz tone burst.
3RZHU*XDUG
During normal operation, the Front Panel Power
Guard Indicators will momentarily illuminate dur-
ing peaks in the audio signals. In the event the MA/
MAC6700 over heats, due to improper ventilation,
high ambient temperature and/or impedance mis-
match, the internal protection circuits will activate.
The Front Panel Power Guard Indicators will continu-
ously illuminate and the audio will be muted. When
Pressing the Mute Push-button a second time or
adjusting the volume control will un-mute the MA/
MAC6700.
+HDGSKRQHV-DFN
Connect a pair of dynamic headphones to the Head-
phones Jack for private listening. Press OUTPUT
1 and/or 2 Push-buttons to mute the Loudspeakers.
Refer to figure 50.
Note: The Headphone Output is optimized for imped-
ances ranging from 20 to 600 ohms.
Power Output Meters
The MA/MAC6700 Power Output Meters indicate the
power delivered to the Loudspeakers. Refer to figure
84. The meters respond to all the musical information
being produced by the Amplifier. They indicate to an
Figure 84
Jumpers
Figure 85
How to Operate the MA/MAC6700, con’t
Figure 83
SOURCE: CD
MUTE
Figure 50