Owner`s manual

14
Specifications
Specifications
Power Output Stereo
Minimum sine wave continuous average power output per
channel, all channels operating is:
120 watts into a 4 ohm load
80 watts into a 8 ohm load
Power Output Mono
Minimum sine wave continuous average power output per
channel, all channels operating is:
275 watts into a 8 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.005% for 4 or 8 ohm loads (Stereo)
0.005% for 8 ohm loads (Mono)
Dynamic Headroom
1.8dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Sensitivity
0.8Volts
A-Weighted Signal To Noise Ratio
92dB (113dB below rated output)
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output per channel does not exceed
twice the rated output, for any combination of fre-
quencies from 20Hz to 20,000Hz, with all channels
operating is:
0.005% for 4 or 8 ohm loads (Stereo)
0.005% for 8 ohm loads (Mono)
Input Impedance
20,000 ohms
Wide Band Damping Factor
100 at 4 ohms
200 at 8 ohms
Power Requirements
100 Volts, 50/60Hz at 9.4 amps
110 Volts, 50/60Hz at 8.5 amps
120 Volts, 50/60Hz at 5.9 amps
220 Volts, 50/60Hz at 4.3 amps
230 Volts, 50/60Hz at 4.0 amps
240 Volts, 50/60Hz at 3.9 amps
Note: Refer to the rear panel of the MC126 for the correct
voltage.
Dimensions
Front Panel: 17-1/2 inches (44.45cm) wide, 7-1/8 inches
(18.10cm) high. Depth behind front mounting panel is 18
inches (45.72cm). Clearance required in front of the Front
Panel is 1 inch (2.54cm) for knobs.
Weight
58 pounds (26.3 kg) net, 77 pounds (34.9 kg) in shipping
carton