Owner's Manual

18
6SHFL¿FDWLRQV
6SHFL¿FDWLRQV
Power Output
Minimum sine wave continuous average power output
per channel, with both channels operating is:
150 watts into 2 ohm load
150 watts into 4 ohm load
150 watts into 8 ohm load
2XWSXW/RDG,PSHGDQFH
2, 4 or 8 ohms
5DWHG3RZHU%DQG
20Hz to 20,000Hz
Total Harmonic Distortion
0.005% maximum harmonic distortion at any power
level from 250 milliwatts to rated power, 20Hz to
20,000Hz
'\QDPLF+HDGURRP
2dB
)UHTXHQF\5HVSRQVH
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3.0dB from 10Hz to 100,000Hz
,QSXW6HQVLWLYLW\IRUUDWHGRXWSXW
2.4 Volts Balanced
1.2 Volts Unbalanced
6LJQDO7R1RLVH5DWLR$:HLJKWHG
G%%DODQFHGG%EHORZUDWHGRXWSXW
G%8QEDODQFHGG%EHORZUDWHGRXWSXW
,QWHUPRGXODWLRQ'LVWRUWLRQ
0.005% maximum, if the instantaneous peak power
output does not exceed twice the rated power output
for any combination of frequencies from 20Hz to
20,000Hz.
:LGH%DQG'DPSLQJ)DFWRU
Greater than 40
,QSXW,PSHGDQFH
22,000 ohms Balanced
22,000 ohms Unbalanced
9ROWDJH*DLQ
23dB, 2 Ohms
26dB, 4 Ohms
29dB, 8 Ohms
3RZHU*XDUG
Less than 2% Total Harmonic Distortion with up to a
14dB overdrive signal
3RZHU&RQWURO,QSXW
5-15VDC, less than 1mA
Power Control Output
12VDC, 50mA maximum
Output is delayed 0.2 seconds from turn On
3RZHU5HTXLUHPHQWV
Field AC Voltage conversion of the MC152 is not
possible. The MC152 is factory configured for one of
the following AC Voltages:
100V ~ 50/60Hz at 4.4 Amps
110V ~ 50/60Hz at 3.7 Amps
120V ~ 50/60Hz at 3.7 Amps
220V ~ 50/60Hz at 2.0 Amps
230V ~ 50/60Hz at 1.9 Amps
240V ~ 50/60Hz at 1.9 Amps
Standby: less than 0.3 watt
Note: Refer to the rear panel of the MC152 for the cor-
rect voltage.
Overall Dimensions
:LGWKLVLQFKHVFP
+HLJKWLVLQFKHVFPLQFOXGLQJIHHW
'HSWKLVLQFKHVFPLQFOXGLQJWKH)URQW3DQHO
and Cables
:HLJKW
SRXQGVNJQHWSRXQGVNJLQVKLSSLQJ
carton
6KLSSLQJ&DUWRQ'LPHQVLRQV
:LGWKLVLQFKHVFP
+HLJKWLVLQFKHVFP
'HSWKLVLQFKHVFP