Owner's Manual

9
Note: The illustration on separate sheet “Mc1A” is
FRQQHFWLRQVIRUȍRKPV/RXGVSHDNHUV
If the Loudspeaker’s impedance is in-between the
available connections, use the nearest lower imped-
ance connection. Refer to “General Information” Note
3 on page 3 for additional information.
WARNING: Loudspeaker terminals are hazard-
ous live and present a risk of electric
shock. For additional instruction on
making Loudspeaker Connections con-
tact your McIntosh Dealer or McIn-
tosh Technical Support.
9. Connect the MC152 power cord to an active AC
outlet.
Output Terminals. The terminals are indentified
DVȍRKPVȍRKPVRUȍRKPVFRQQHFWLRQ
to match the impedance of the Loudspeaker, being
careful to observe the correct polarities.
Note: The illustration on separate sheet “Mc1A” is
FRQQHFWLRQVIRUȍRKPV/RXGVSHDNHUV
If the Loudspeaker’s impedance is in-between the
available connections, use the nearest lower imped-
ance connection. Refer to “General Information” Note
3 on page 3 for additional information.
WARNING: Loudspeaker terminals are hazardous
live and present a risk of electric shock.
For additional instruction on making
Loudspeaker Connections contact your
McIntosh Dealer or McIntosh Techni-
cal Support.
7. Connect the MC152 power cord to an active AC
outlet.
6SDGH/XJRU:LUH&RQQHFWLRQV
8. Connect the Loudspeaker hookup cables to the
MC152 Negative Output Terminal and Positive
2XWSXW7HUPLQDOLQGHQWLILHGDVȍRKPVȍ
RKPVRUȍRKPVFRQQHFWLRQWRPDWFKWKH
impedance of the Loudspeaker, being careful to
observe the correct polarities. Insert the spade
lug connector or prepared section of the cable end
into the terminal side access hole, and tighten the
terminal cap until the cable is firmly clamped into
the terminals so the lugs or wire cannot slip out.
Refer to figures 7 and 8.
Output Terminals and How to Connect
Figure 7
Figure 8