Owners Manual

6
Installation
The MC207 can be placed upright on a table or shelf,
standing on its four feet. It also can be custom installed in
a piece of furniture or cabinet of your choice. The four feet
may be removed from the bottom of the MC207 when it is
custom installed as outlined below. The four feet together
with the mounting screws should be retained for possible
future use if the MC207 is removed from the custom in-
stallation and used free standing. It also can be custom
installed in a piece of furniture or cabinet of your choice
The required panel
cutout, ventilation
cutout and unit di-
mensions are shown.
Always provide
adequate ventilation
for your MC207.
Cool operation en-
sures the longest
possible operating
life for any elec-
tronic instrument.
Do not install the
MC207 directly
above a heat gen-
erating component
such as a high pow-
ered amplier. If all
the components are
installed in a single
cabinet, a quiet run-
ning ventilation fan
can be a denite
asset in maintaining
all the system com-
ponents at the cool-
est possible operat-
ing temperature.
A custom cabinet
installation should
provide the follow-
ing minimum spac-
ing dimensions for
cool operation. Al-
low at least 6 inches
(15.24cm) above
the top, 2 inches
(3.81cm) below the
Installation
8- 5/16 "
21.11cm
17- 1/16 "
43.34cm
MC207 Front Panel
Custom Cabinet Cutout
Cutout
Opening
for
Ventilation
Cutout Opening for Ventilation
Support
Shelf
Cabinet
Front
Panel
Chassis
Spacers
MC207 Side View
in Custom Cabinet
MC207 Bottom View
in Custom Cabinet
12 -1/4 "
31.12cm
12 -3/8 "
31.43cm
11 -1/2 "
29.21cm
3 -3/4 "
8.57cm
Cutout Opening
for
Custom Mounting
6"
15.24cm
Opening
for Ventilation
Center the
opening horizontally
with the
MC207 Chassis
15 -3/4 "
40.00cm
9 -7/8 "
25.08cm
11"
27.9cm
bottom and 1 inch (2.54cm) on each side of the amplier,
so that airow is not obstructed. Allow 20 inches (50.8cm)
depth behind the front panel. Allow 1 inch (2.54cm) in
front of the mounting panel for knob clearance. Be sure to
cut out a ventilation hole in the mounting shelf according
to the dimensions in the drawing.