McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York McAire Integrated Audio System Owner’s Manual 13903-2699 Phone: 607-723-3512 www.mcintoshlabs.
The lightning flash with arrowhead, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. WARNING - TO REDUCE RISK OF FIRE OR ELECTRICAL SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE. IMPORTANT SAFETY INSTRUCTIONS! PLEASE READ THEM BEFORE OPERATING THIS EQUIPMENT. 1. Read these instructions. 2. Keep these instructions. 3.
Trademark and License Information FCC INFORMATION (For US and Canada Customers) a) User Information acc. to FCC15.21 as following: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. b) Statement for Class B digital device acc. to FCC 15.105 as following: NOTE: This equipment has been tested and found to comply with the limits for a Class A/B digital device, pursuant to part 15 of the FCC Rules.
Thank You Your decision to own this McIntosh McAire Integrated Audio System ranks you at the very top among discriminating music listeners. You now have “The Best.” The McIntosh dedication to “Quality,” is assurance that you will receive many years of musical enjoyment from this unit. Please take a short time to read the information in this manual. We want you to be as familiar as possible with all the features and functions of your new McIntosh.
General Information, Connector Information, Introduction and Performance Features General Information 1. For additional connection information, refer to the owner’s manual(s) for any component(s) connected to the McAire Integrated Audio System. 2. The Main AC Power going to the McAire should not be applied until instructed to do so. Failure to do so could result in malfunctioning of normal operations.
Dimensions The following dimensions can assist in determining the best location for your McAire. Front View of the McAire 19-3/8" 49.2cm 6-1/4" 15.9cm Side View of the McAire 14-7/16" 36.7cm 8" 20.3cm Rear View of the McAire 12-15/16" 32.8cm Secondary Low Frequency Acoustic Openings Note: For proper Low Frequency Performance do not block the Acoustic Opening.
Dimensions Front and Inside View of the McAire with the Loudspeaker Grilles removed and the internal Woofers shown Bottom View of the McAire Foot Primary Low Frequency Acoustic Opening Note: For proper Low Frequency Performance do not block the Acoustic Opening, remove or change the four feet on the bottom of the McAire.
Dimensions and Installation Installation The McAire is designed to be placed upright on a table or shelf with a reflective surface. For proper Low Frequency performance do not block the Acoustic Opening, remove or change the four feet on the bottom of the McAire. Refer to the illustration on the previous page for additional information. The ventilation requirements are as illustrated on this page. Always provide adequate ventilation for your McAire.
Rear Panel Connections WLAN (Wireless Local Area Network) ANTENNA for receiving AirPlay and WiFi signals MAC ADDRESS is the unique Network Identification Number for this McAire unit NETWORK Connector for connecting the McAire to a Broadband Ethernet Network Connect the McAire power cord to a live AC outlet.
Connecting the Antenna Connecting the McAire For proper wireless connectivity with the Wireless Network Router, it is important install the supplied WiFi Signal Antenna to the McAire. Follow the steps below: 1. Locate the supplied WiFi Antenna, AC Cord and Remote Control in the Accessory Pack Sleeves from the McAire inner carton. Refer to page 23 in this Owner’s Manual. 2.
Connecting the McAire Apple iPod or iPhone Connect to AC Outlet when instructed to do so Optional Tuner or Disc Player Optional Computer Network Router (Wireless or Wired) Refer to page 15 for additional information Connect to AC Outlet 30 11
Remote Control Push-Buttons Tunes Up the Dial with optional McIntosh Tuner connected to the McAire Press and hold to switch the meter illumination On or Off.
How to use the Remote Control How to use the Remote Control The supplied Remote Control performs the various Operating Functions for the McAire Integrated Audio System. Note: Refer to the “How to Operate” Section of this manual for additional information. Input Source Selection Press the Push-button → to select the desired program source. Volume Press the + or - Push-buttons to increase or decrease the listening level. Mute Press the (Mute) Push-button to mute the audio.
Front Panel Displays, Controls and Push-button Meter indicates the Right Channel Output of the amplifier Meter indicates the Left Channel Output of the amplifier Select from one of the various Input Sources available for listening ON/STANDBY Push-button switches the McAire ON or OFF (Standby) Indicates the current INPUT Selection and operational status 14 VOLUME Control adjusts the listening level for both channels Indicates when the McAire is in standby mode and operational status Indicates when t
How to Setup the McAire for AirPlay® and a Network Connection Introduction to Setting Up the McAire Your McIntosh McAire is factory configured for immediate enjoyment of superb audio from an iPod Touch or iPhone (Mobile Device). Just connect it to the McAire iPod/USB Rear Panel Connector using your Apple Dock Connector to USB Cable. Refer to page 20 “How to Operate the McAire” for additional information using the USB Input.
Method Number 1, con’t 4. Press the ENTER on the keyboard. After several minutes the McIntosh McAire Setup Screen will appear in the web browser window. Refer to figure 3. Figure 5 Figure 3 5. Referring to figure 3, select “Your Router” (MAC Address) from the choices appearing in the SSID pull down window. Refer to figure 4. Note: The Router is Figure 4 identified by the MAC Address (unique number for each Router) and is on a label usually located on the Router.
How to Setup the McAire for AirPlay and a Network, con’t a network connection is trying to be established. Figure 11 Figure 12 Method Number 2 Unlike Setup Method #1, this method uses the McAire (instead of a computer) to establish communications with a Wireless Router using your Apple Mobile Device. After setup up is completed, a Wireless Router will still be needed to stream music from your Apple Mobile Device to the McAire via AirPlay. Perform the following setup steps: 1.
Method Number 2, con’t 10. Referring to figure 17, touch the APPLY button On-Screen to continue. Figure 17 11. From the Settings Menu select the Wi-Fi Icon. Refer to figure 18A. 12. From the “Choose a Network” options select the MAC Address of the Network Router (same address as selected in step 8 on page 17). Refer to figure 18B. Touch the “Your Router” a second time to activate the wireless connection and a check mark will appear to the Figure 18A left of the MAC Address or unique Router name.
How to Setup the McAire for AirPlay and a Network, con’t Method Number 3 This method uses the McAire, your Apple Mobile Device and Apple Dock Connector to USB Cable. Perform the following setup steps: 1. Switch power On to the Router and locate the MAC Address (on a label usually located on the Router) or the unique Router name as it will be needed in step 4. 2. Activate the Apple Mobile Device and select the Settings Icon. Refer to figure 19 on page 18. 3. From the Settings Menu select the Wi-Fi Icon.
How to Operate the McAire Your McIntosh McAire is factory configured for immediate enjoyment of superb audio from an iPod Touch or iPhone (Mobile Device). Just connect it to the McAire iPod/USB Rear Panel Connector using the Apple Dock Connector to USB Cable. If you wish to make an AirPlay wireless connection between the Mobile Device and the McAire, please refer to “How to Setup the McAire” on page 15 for additional information.
How to Operate the McAire Streaming music from Apple Mobile Device To stream music stored in the Apple Mobile Device directly to the McAire, perform the following: 1. Touch the AirPlay Icon on the Music App. Refer to figure 32. 2. From the list appearing on the Apple Mobile Device select the McAire. Refer to figure 33. 1. Switch On the McAire. 2. Launch iTunes and click the AirPlay icon displayed in the AirPlay icon lower right of the window and then select McAire from the list.
Specifications Electronic Specifications Loudspeaker Specifications General Specifications Network Input Wired RJ45, 10/100 Base-T Wireless 802.11, WPA Apple AirPlay System Driver Complement Two 4 inch Woofers (dual acoustic ports) Two 2 inch Inverted Dome Midranges Two 3/4 inch Dome Tweeters USB Input Type A Connector with Host Mode Music Streaming 1Amp Charging for iPhone and iPod Frequency Response 60Hz - 45kHz Power Requirements Field AC Voltage conversion of the McAire is not possible.
Packing Instructions Packing Instructions ACCESSORY PACK SLEEVE In the event it is necessary to repack the equipment for shipment, the equipment must be packed exactly as shown below. Failure to do this will result in shipping damage. Use the original shipping carton and interior parts only if they are all in good serviceable condition. If a shipping carton or any of the interior part(s) are needed, please call or write Customer Service Department of McIntosh Laboratory. Refer to page 4.
McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, NY 13903 www.mcintoshlabs.com The continuous improvement of its products is the policy of McIntosh Laboratory Incorporated who reserve the right to improve design without notice. Printed in the U.S.A. McIntosh Part No.
