Owner`s manual

McIntosh CD Player

How to Connect for Power Control and Data

The Power Control Connections facilitate the ability to

switch power On and Off to the McIntosh Source Compo-

nents automatically with the McIntosh Control Center/

Preamplifier. Data Control Connections facilitate the ability

to remotely operate McIntosh Source Components using the

supplied MDA1000 D/A Converter Remote Control or the

McIntosh Control Center/Preamplifier Remote Control.

1. Connect a Power Control Cable from the MDA1000

POWER CONTROL IN Jack to the appropriate Power

Control Out Jack on the McIntosh Control Center/

Preamplifier.

Note: If the MDA1000 is connected to a McIntosh

MCD1000 CD Transport in a system without a

McIntosh Control Center or Preamplifier, the

MDA1000’s Power Control In should be connected

to the MCD1000 Power Control Out Jack.

2. Connect a Power Control Cable from the MDA1000

POWER CONTROL OUT Jack to the McIntosh

MCD1000 CD Transport Power Control In Jack.

3. Optionally, connect a Power Control Cable from the

MCD1000 Power Control Out Jack to the McIntosh

CD Player Power Control In Jack.

4. Connect a Data Control Cable from the MDA1000

DATA IN Jack to the LINE 1 Data Port on the McIn-

tosh Control Center/Preamplifier.

5. Connect a Data Control Cable from the MDA1000

DATA SWITCHED DATA OUTPUTS Jack 1 to the

McIntosh MCD1000 CD Transport Data In Jack.

6. Connect a Data Control Cable from the MDA1000

DATA SWITCHED DATA OUTPUTS Jack 4 to the

McIntosh CD Player Data In Jack.

McIntosh MCD1000 CD Transport

McIntosh Controller