Diagram

MP1100 Phono Preamplifier Connection Diagram

McIntosh Laboratory, Inc. 2 Chambers Street Binghamton, New York 13903-2699 Phone: 607-723-3512 FAX: 607-724-0549 Part No. 04173000

Integrated Amplifier requiring Analog to Digital Conversation

Computer

Tur ntable 2

Tur ntable 1

Note: Refer to the MP1100 Owner’s Manual page 9 for additional connection information.

Connection Legend:

Data Cable*- Digital Signal Cable -

Sensor/Keypad Cable - RS232 Cable -

Power Control Cable* - Ground Wire -

Audio Signal Cable - AC Power Cords -

Video Signal Cable - Loudspeaker Cable -

RF Signal Cable -

* 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.

Connect to

AC Outlet

Analog Preamplifier

Digital Preamplifier

Connection from

the Preamplifier

Power Control

(Trigger Out)

IR Sensor

PAGE 1
A MP1100 Phono Preamplifier Connection Diagram Note: Refer to the MP1100 Owner’s Manual page 9 for additional connection information. Analog Preamplifier Connection Legend: Data Cable*Digital Signal Cable Sensor/Keypad Cable RS232 Cable Power Control Cable* Ground Wire Audio Signal Cable AC Power Cords Video Signal Cable Loudspeaker Cable RF Signal Cable * 2 conductor shielded with 1/8 inch stereo mini phone plug on each end.
PAGE 2
1B MP1100 Rear Panel Connections RIGHT LINE INPUT 2 balanced input receives analog signals for listening to and/or converting into a digital signal RIGHT OUTPUT BALanced sends signals to a Preamplifier or a recording device RIGHT OUTPUT unbalanced sends signals to a Preamplifier or a recording device LEFT PHONO INPUT 3 BALanced Input accepts signals from Moving Magnet or Moving Coil Phono Cartridges RIGHT PHONO INPUT 3 BALanced Input accepts signals from Moving Magnet or Moving Coil Phono Cartridges R