Owner's Manual

19
Information Display. Refer to figure 67.
4. To select Profile momentarily press the Front Panel
INPUT Control (TRIM) or the TRIM Push-button
on the Remote Control. Refer to figure 68.
5. To select the desired profile (User Profile “U1”)
rotate the Front Panel LOAD Control or press the
p
and q Push-buttons on the Remote Control.
Refer to figure 69.
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
RESISTANCE
Change the Resistance Load Setting for a selected
Phono Cartridge by performing the following Steps:
1. Select the desired PHONO Input Source.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select “RESISTANCE, Ohm 47k”as
indicated on the Front Panel Information Display.
Refer to figure 70.
ed, except the Sample Rate,
Meter Illumination and
Display Brightness settings
of On or Off, which are the
same for all inputs.
Note: Selection and Adjust-
ment of all Trim
Functions may be
performed by press-
ing the Front Panel
INPUT Trim Control
and then rotating it
to select the desired
Trim Function. Then
use the LOAD Control
to change the setting.
The Remote Control
TRIM Push-Button
together with the
Directional Push-buttons can also be used. After
pushing the TRIM Push-button, use the t and u
Push-buttons to select the desired TRIM Function,
and then use p and q Push-buttons to adjust the
selected TRIM Setting, refer to figures 60 and 66.
CARTRIDGE PROFILE
There are four default Cartridge Profile Settings and
the MP1100 has the ability to store up to five addition-
al Custom Cartidge Profile Settings. Refer to Setup
“Profile Store’ on page 15 for additional information.
1. Select the desired PHONO Input Source.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select “CARTRIDGE PROFILE, (Press
TRIM to Set)” as indicated on the Front Panel
How to Operate the MP1100
Figure 67
CARTRIDGE PROFILE
(Press TRIM to Set)
Figure 68
CARTRIDGE PROFILE
MM
Figure 69
CARTRIDGE PROFILE
User Profile 1 (U1)
4. To select the resistance of 100 ohms, rotate the
Front Panel LOAD Control or press the p and
q Push-buttons on the Remote Control. Refer to
figure 71.
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
CA PACITA NCE
Change the Capacitance Load Setting for a selected
Phono Cartridge by performing the following Steps:
1. Select the desired PHONO Input Source.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t
and u Push-buttons on the Remote
Control to select “CAPACITANCE, pF 50” as
indicated on the Front Panel Information Display.
Refer to figure 72.
4. To select the a capacitance of 300 pF, rotate the
Front Panel LOAD Control or press the p
and
q Push-buttons on the Remote Control. Refer to
figure 73 on the next page.
Figure 70
RESISTANCE
Ohm 47k
Figure 71
RESISTANCE
Ohm 100
Figure 72
CAPACITANCE
pF 50
Figure 66