Owner's Manual

21
4. To activate the Scratch Filter, rotate the Front Panel
LOAD Control or press the p and q Push-buttons
on the Remote Control. Refer to figure 84.
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
DIGITAL OUT LEVEL
The MP1100 provides the greatest possible Dynamic
Range when converting the Analog Audio Signal from
the playback of Phonograph Recordings to a Digital
Audio Signal. There are two Digital Output Settings
to accommodate a wide range of Dynamic Range. For
most recordings, the default setting of Digital Output
High Setting will produce excellent results. Refer-
ring to figure 85, if the word CLIP Flashes on the
Front Panel Information Display, switching the Digital
Out put to the Low Set ting will produce better results.
To change the Digital Out Setting from High to Low
perform the following steps:
1. Select the desired PHONO Input Source.
Note: Phono 1 was selected for this example.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t
and u Push-buttons on the Remote
How to Operate the MP1100, con’t
Note: For additional information on the Equalizer
Settings, refer to page 27.
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
RUMBLE FILTER
Reduce unwanted Low Frequence Noise known as
Rumble by using the MP1100 Rumble Filter. To acti-
vate the Rumble Filter perform the following Steps:
1. Select the desired PHONO Input Source.
Note: Phono 1 was selected for this example.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t
and u Push-buttons on the Remote
Control to select “RUMBLE FILTER, Off” as
indicated on the Front Panel Information Display.
Refer to figure 81.
4. To activate the Rumble Filter, rotate the Front Panel
LOAD Control or press the p and q Push-buttons
on the Remote Control. Refer to figure 82.
After approximately 6 seconds the Information
Display returns to indicate the Source Selection and
Settings.
SCRATCH FILTER
Reduce unwanted High Frequence Noises known
as Scratches by using the MP1100 Scratch Filter. To
activate the Scratch Filter perform the following Steps:
1. Select the desired PHONO Input Source.
Note: Phono 1 was selected for this example.
2. Momentarily press the Front Panel INPUT Control
(TRIM) or the TRIM Push-button on the Remote
Control.
3. Rotate the Front Panel INPUT Control (TRIM) or
press the t and u Push-buttons on the Remote
Control to select “SCRATCH FILTER, Off” as
indicated on the Front Panel Information Display.
Refer to figure 83.
Figure 77
EQUALIZER
LP
Figure 78
EQUALIZER
NAB
Figure 79
EQUALIZER
AES
Figure 80
EQUALIZER
78
Figure 81
RUMBLE FILTER
Off
Figure 82
RUMBLE FILTER
On
Figure 83
SCRATCH FILTER
Off
Figure 84
SCRATCH FILTER
On
Figure 85
MM PHONO 1 RIAA
pF 50 CLIP Ohm=47K