Owner's Manual

How to Connect Antennas

How to Connect Antenna Components

1. Using the supplied shielded cable, connect one end

into the RAA2 AM Antenna jack and the other

end of the same cable into the MR87 Tuner jack

labeled RAA2 AM ANT.

Note: If a longer length cable needs to be used between

the MR87 and the RAA2 AM Antenna, use an 8

conductor straight-thru cable with an outer shield

and RJ45 connectors on each end (shielded CAT5,

CAT5e or CAT6 patch cable).

2. Connect a 75 ohm coax cable from a FM Antenna

or cable system to the MR87, 75 OHM FM ANT

Connector.

Mounting the RAA2 AM Antenna

Tune to a station with the weakest signal and orient the

RAA2 Antenna for maximum signal with minimum

noise and distortion. After the location is determined,

the RAA2 AM Antenna

may be secured to a

suitable surface by using

two #6 1-3/4 to 2 inches

(4.44 to 5.08cm) long

screws, refer to the il-

lustration to the right.

FM Antenna